Initial Settings menu, Component Out | Pioneer XV-DV313, S-DV313

Initial Settings menu

•Default setting: Video

•If you make a setting here that is incom- patible with your TV, the TV may not display any picture at all. If this happens switch everything off and reconnect to the TV using the supplied audio/video cable.

•SCART cables come in various configura- tions. Make sure you use the correct one for your TV/monitor. See page 72 for the SCART pin assignment diagram.

Initial Settings
Video Output	TV Screen	Video
Language	AV Connector Out	S-Video
Display		RGB
Options

•Video – Standard video, compatible with all TVs.

•S-Video– Higher quality, but check your TV for compatibility.

•RGB – Best quality, but check your TV for compatibility.

Component Out

Not Applicable to the European model

You only need to make this setting if you connected this system to your TV using the component video outputs.

• Default setting: Interlace

Initial Settings
Digital Audio Out
Digital Audio Out	TV Screen	Interlace
Video Output	Auto Progressive	Progressive
Language	Component Out
Display	S-Video Out
Options

If you have a progressive-scan compatible TV, set this to Progressive for flicker-free video output. If your TV is not compatible with progressive-scan video, set to Interlace. Check the operating instructions that came with your TV if you’re unsure about its compatibility.

When setting to Progressive, you have to press ENTER once more to confirm (or RETURN to cancel). See also below for important information on progressive scan video.

About progressive scan video

Compared to interlace video, progressive scan video effectively doubles the scanning rate of the picture, resulting in a very stable, flicker-free image. Progressive scan video is available only from the component video output.

•When TV format is set to AUTO or NTSC only: When Component Out (above) is set to Progressive, there is no video output from the VIDEO and S-VIDEOjacks. If you want to display video on more than one monitor simultaneously, make sure that it is set to Interlace. See also Setting the TV format on page 73.

•If you connect a TV that is not compatible with a progressive scan signal and switch the system to progressive, you will not be able to see any picture at all. In this case,

press STANDBY/ON to put the system in standby, then press and hold the front panel (stop) button for about 8 seconds until the display shows Mem.Clr.?. Press the front panel VOLUME – (DOWN) or + (UP) button so that the display shows Interlace?. Press the front panel button to set to interlace and switch the system back on.

Pioneer XV-DV313, S-DV313 Initial Settings menu, Component Out, About progressive scan video