Replacing iH9 Backup Batteries, Radio

Using the iH9

Radio

Setting up Antennas

a) Snap AM loop antenna into provided stand, then plug AM antenna cable into AM Loop Antenna socket on back of unit. Move antenna 12” away from unit for best reception.

b) Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

a)Press the Radio Button to select radio play mode. Press as needed to select FM or AM radio band.

b)Turn the Set Wheel to tune radio to a desired station.

c)	To program	the current station as a preset, press and hold Preset Button 1-2 until P1 flashes on display; press again for
	P2 and allow to time-out (beep confirmation). Repeat steps a,b,and c for other preset buttons to preset up to 12 stations (6 AM,
	6 FM). To listen to a preset station at any time, simply press the desired preset button once or twice.
d) Turn the		Volume Wheel to adjust iH9 volume up or down.
e)	Press the	EQ Button to select Treble, Bass, 3D sound effect or Balance. Turn the Set Wheel to adjust settings. EQ settings
	for iPod and radio mode are independent.
f)	Press Alarm Reset/Power Button to turn iH9 off.

Using the Line-in and Line-out Jacks

a) An audio patch cord comes with the iH9. Use it to play nondocking iPods or other audio devices through the iH9 Line-in Jack (connect one end in the device’s line out or headphones jack, the other in the iH9 line-in jack). Make sure there is no iPod


	docked in the iH9 when using the line-in jack.
b)	To listen to your audio device, press the		Radio Button until line-in is displayed, indicating line-in mode. Adjust the output
	volume on your line-in device.
c)	Use the	Line Out Jack to connect the iH9 to the line-in jack of other audio devices such as a tape recorder or amplifier.
	The Volume Wheel of the iH9 does not control line-out volume (adjust on attached device instead). The Line Out Jack is not
	for headphones.

Using Sleep Mode

Sleep mode lets you sleep to your iPod or the radio, gradually lowering the volume until the unit shuts off at the selected time. a) Press the Sleep Button to select an amount of time before the iH9 shuts off: 120, 90, 60, 30 or 15 minutes.

b) Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting).

Using the Dimmer

a) Press the Snooze/Dimmer Button during normal operation to adjust brightness of LCD display. There are 8 levels of brightness including OFF.

Replacing iH9 Backup Batteries

Install/Replace Backup Battery

The iH9 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement.

Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries as indicated. We recommend the use of alkaline batteries for longer life.

Batteries information:

• Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.