iHome manual Using iH16, Charging Your iPod, Listening to Your iPod

Page 7

Using iH16

Install AC Adaptor

Connect the AC adaptor cable plug into the jack on the back of the ih16, then plug the AC adaptor into the wall outlet.

Install iPod Insert

 

Your iH16 comes with a double-sided insert to ensure certain iPod models fit properly in

 

the dock. To place an insert:

 

1.

Identify the side of the insert that matches your iPod model (see table on page 1).

 

2.

Gently press the iPod insert into the dock with the proper side facing the connector

Install iPod Insert

 

pins.

3.

Carefully place your iPod into the dock. The iPod must not be in a case or “skin”.

 

Installing/Replacing Batteries for Portable Operation

The iH16 uses 4 “AA” batteries for portable operation. The iH16 will not charge your iPod while operating on batteries.

If sound becomes weak or distorted, it is time to replace the batteries.

• Open the battery compartment cover located on the bottom of the unit.

• Insert 4 “AA” batteries as indicated.

• We recommend the use of alkaline batteries for longer life.

NOTE: To save battery life, when running on batteries, unit will automatically

power OFF after 3 minutes of non-use (no song playing).

Batteries information:

• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.

Charging Your iPod

Note: Please make sure you are using the correct side of the insert for your iPod model, if needed (see Install iPod Insert) and that your iPod is properly docked into the iH16.

1.While your iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged. iPod will not be overcharged. Unit will not charge iPod when operating on batteries.

Listening to Your iPod

1.Dock an already playing iPod and the iH16 will automatically turn on.You will hear the music playing from your iPod. Note: If the volume on the playing audio is too low on the iPod, the iH16 may not detect that the iPod is in play mode. Press the button once to play iPod.

2.When the iPod is docked and in standby mode, press the button on the iH16 to play your iPod.

3.Press play/pause on your iPod to pause play; press again to resume it.

4.

Press the or

 

buttons on the iH16 to adjust the system volume.

 

5.

To turn off the unit, press the

button on the iH16. Your iPod will continue charging while in the dock.

4

Image 7
Contents Portable Alarm Clock Speaker System for your iPod Maintenance Table of ContentsGetting Started For models that use Lithium batteries Battery WarningFor models that require more than one battery FCC InformationQuick Start Controls and Indicators Close the compartment door Install Clock Backup BatteryIndicator IH16 DisplayCharging Your iPod Using iH16Listening to Your iPod Press the button to turn the iH16 on Setting Up the iH16Setting the Clock Time Listening to non-docking iPod or other audio devicesSetting the Alarm Alarm OperationPress and hold Snooze/Dimmer Operation Sleep OperationConsumer Guide to Product Safety Wall outlet is not functioning Trouble ShootingNo power IPod battery has problemSolucionando Problemas Limited 90-Day Warranty Information