PYLE Audio PIWPD3 important safety instructions Troubleshooting Guide, Solution

Page 4

1.Slide the Combination dead bolts to unlock position.

2.Press the Open buttons to detach the speakers from the main base.

Using the Aux-in Jack

TROUBLESHOOTING GUIDE

Should you experience difficulties in the use of this player, please refer to the following chart.

1.Press and hold the Play/Pause on the main base or press the Power on button on remote control to turn on the main base, the power on indicator will turns on with red color if there is no an iPod or iPhone docked on the main base.

Note: the power on indicator turns to red color means the docking station is in AUX-IN mode.

2.Connect an audio cable to the headphone or line-out jack of an audio device and plug the other end into the Aux -in jack located on back of the main base

3.Turn audio device on and play this device.

4.Rotary the volume knob to choose a proper volume level, When

finished, press and hold the Play/Pause on the main base or press the Power on button on remote control to turn off the main base. Remember to turn off the speakers and your audio device, too.

VIDEO OUT FROM THE iPod/iPhone

1.You can connect this unit to a television or other video display that has a composite video input.

2.Securely dock your iPhone or iPod with video.

3.Connect one end of an RCA cable (not included) to rear RCA video jack on the unit.

4.Connect the other end of the RCA cable to VIDEO IN of television or video display.

5.Press the FUNCTION button to select iPod/iPhone mode.

6.Select a movie from your iPod/iPhone menu.

7.iPod: On the main menu choose video then select video setting.

8.iPod: Make sure the TV Out section is set to "ON".

9.iPod: Switch back to the movie library and play the movie of your choice

Note: Video out will automatic when using an iPod touch or iPhone

Symptom

The base does not switch on (no power)

iPod/iPhone does not respond to the speaker system

iPod/iPhone does not charge up

Speakers do not play the sound from docked device

Sound is cut off or noisy

Sound is distorted

Possible problem

AC adaptor is not plugged into a wall outlet or the connector is not plugged into the DC jack on the back of the unit.

Wall outlet is not functioning.

Using no/wrong iPod cradle.

iPod/iPhone is not installed properly.

Your iPod/iPhone is locked up.

iPod/iPhone is not installed properly.

iPod/iPhone battery has problem.

Speakers receive signal from other devices, or the other set of MW-1025A

The unit experiences interference

Sound source is distorted.

Volume level is set too high.

Solution

Plug the AC adaptor into a wall outlet and plug the connector into the DC jack on the unit.

Plug another device into the same outlet to confirm the outlet is working.

Make sure the dock cradle is the proper fit for your iPod.

Remove your iPod/iPhone from the dock and check for any obstruction on the connectors in the docking and on your iPod. Then reseat it in the dock.

Please make sure that your iPod/iPhone is working properly before docking into the unit.

Remove your iPod/iPhone from the dock and check for any obstruction on the connectors in the docking and on your iPod. Then reseat it in the dock.

Please make sure your iPod/iPhone is working properly before docking into the unit.

Place the unit to a location where receive lesser external signal.

Do not turn on other wireless devices simultaneously.

If the source is iPod/iPhone, try to check the sound at personal computer before putting into the iPod/iPhone. If you are using an external sound source like digital audio player, try reducing the output volume on the device itself.

Decrease the volume.

7

8

Image 4
Contents Important Safety Instructions Remote Control Location of ControlsPower Sources AccessoriesGeneral Operation Special TipsTroubleshooting Guide SolutionSpecifications Power Supply