Setting up Antennas, Tuning and Playing the Radio

Using the iH3

Radio

Setting up Antennas

a) Snap AM loop antenna into provided stand, then plug antenna cable into AM Loop Antenna socket on back of unit. Move antenna 12” away from unit for best reception.

b) Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

a)Press the Radio Button to select radio play mode.

b) Press the AM/FM Select Button to select AM or FM radio band. c) Turn the Set Wheel to tune radio to desired station.

d) Turn the Volume Wheel to adjust iH3 volume up or down.

e)Press Alarm Reset/Power Off Button to turn iH3 and iPod off.

Using the Line-in and Line-out Jacks

a) An audio patch cord comes with the iH3. Use it to play nondocking iPods or other audio devices through the iH3 Line-in Jack (one end in the device’s line out or headphones jack, the other in the iH3 line in jack). Make sure there is no iPod docked in the iH3 when using the line-in jack. Press the Ipod Button until AUX appears on the display.

b) Use the Line Out Jack to connect the iH3 to the line-in jack of other audio devices such as a tape recorder or amplifier. The Volume Wheel of the iH3 does not control line-out volume (adjust on attached device instead).

Using Sleep Mode

Sleep mode lets you sleep to your iPod or the radio, gradually lowering the volume until the unit shuts off at the selected time.

a) Press the

Sleep Button to select an amount of time before the iH3 will turn off: 120, 90, 60, 30 or 15 minutes.

b) Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting).

Using Dimmer

a) Press the Snooze/Dimmer Button during normal operation to adjust brightness of LCD display.