Roberts Radio CR9923 manual General, Mains supply, FuseCord

Page 11

General

Do not allow this unit to be exposed to water or steam. It is recommended that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW band.

Mains supply

The CR9923 will operate from a supply of AC 230volts, 50Hz only.

E(Earth)

Brown(Live)

3 amp

L

Blue (Neutral)

N

The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK.

The wire coloured BROWN must be connected to the terminal marked L or coloured RED.

For your convenience this product is supplied with a plug which is fitted with a fuse of the appropriate rating. If the plug supplied is not suitable for your socket outlet, it should be removed by unscrewing the plug top, the terminal screws and removing the cable.

The correct style of plug to suit your household together with a correctly rated fuse should be fitted.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN

IMPORTANT. DO NOT make any connection to the larger terminal which

is marked with the letter E or by the safety earth symbol or coloured

Green or Green-and-yellow.

The wires in the mains lead are coloured in accordance with the following codes :-

BLUE - NEUTRALBROWN - LIVE

As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:-

FuseCord

This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.

Back-up Battery (not necessary for the unit to function)

Slide the battery cover downwards. Remove the battery cover.

Fit a 9 volt IEC size 6LR61 (6F22, PP3) or equivalent battery into the compartment. Replace the battery cover.

The time and alarm settings will be retained during a temporary failure of the AC mains supply. The LED display will not be operational. The display will be extinguished to conserve battery life.

If you need any further advice, please call our Technical Helpline on :-

10

020 8758 0338 (Mon-Fri)

 

Image 11
Contents CR9923 Controls top SnoozeControls front Alarm indicator PM indicator Tuning controlControls left and right side Setting the time Switching onListening to the Radio SwitchChecking the alarm time Setting alarm timeSetting the alarm to wake to radio Setting the alarm to wake to buzzerSnooze control Sleep timerSpecifications Circuit Features Dimmer SwitchFuseCord Back-up Battery not necessary for the unit to functionGeneral Mains supplyGuarantee Roberts Radio Technical Services Department