Roberts Radio CR9901 manual General, Mains supply, Fuse, Underside

Page 9

General

Do not allow this unit to be exposed to water or steam. It is recommended that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW or LW bands.

Mains supply

The CR9901 will operate from a supply of AC 230volts, 50Hz only.

For your convenience this product is supplied with a plug which is fitted with a fuse of the appropriate rating. If the plug supplied is not suitable for your socket outlet, it should be removed by unscrewing the plug top, the terminal screws, and removing the cable.

The correct style of plug to suit your household together with a correctly rated fuse should be fitted.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN

IMPORTANT. DO NOT make any connection to the larger terminal which

is marked with the letter E or by the safety earth symbol or coloured Green or Green-and-yellow.

The wires in the mains lead are coloured in accordance with the following codes :-

BLUE - NEUTRAL BROWN - LIVE

As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:-

Fuse

This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.

Back-up Battery (not necessary for the unit to function)

Slide the battery cover catch in the direction of the arrow. Remove the battery cover. Fit a 9 volt IEC size 6LR61 (6F22, PP3) or equivalent battery into the compartment. Replace the battery cover.

The time and alarm settings will be retained during a temporary failure of the AC mains supply. The LED display will not be operational. The display will be extinguished to conserve battery life.

(Underside)

 

E(Earth)

Brown(Live)

3 amp

Blue (Neutral)

L

 

N

 

The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK.

The wire coloured BROWN must be connected to the terminal marked L or coloured RED.

Cord

If you need any further advice, please call our Technical Helpline on :-

0181 758 0338 (Mon-Fri)

8

 

Image 9
Contents CR9901 Controls Top3Left side Right side Controls Front Switching on and setting the time Listening to the Radio Alarm Setting alarm timeChecking the alarm time Setting the alarms to wake to radio Setting the alarm to wake to buzzerDimmer Switch Sleep timerHeadphones on rear Snooze controlGeneral Back-up Battery not necessary for the unit to functionMains supply FuseCircuit Features SpecificationsPage Roberts Radio Technical Services Department