Sirius Satellite Radio SRA-40 instruction sheet Optional Accessories SRS-1

Page 6

Satellite Shooter Template

Trace the triangle below on a sheet of paper, then cut out the triangle and use as a template on thick paper or poster-board.

1.Tape this edge to paper tube or straight edge.

2.Sight through tube or top of straight edge for clear view of sky.

This corner should be next to the mounting hole when scanning.

This edge must be kept horizontal at the mounting location

Optional Accessories

SRS-1

DC Voltage Splitter for antenna cables up to 50’

SRS-2

DC Voltage Splitter for antenna cables over 50’

SRC-35

35’ RG-58 cable kit with connectors

SRC-50

50’ RG-58 cable kit with connectors

SRC-90

90’ RG-8X cable kit with connectors

SRC-135

135’ RG-8X cable kit with connectors and inline amplifier

SM-30

Low-Profile Surface Mounting Kit for locations without access

 

under the antenna for attaching nuts and bolts.

The length of the cable run from the antenna to the satellite radio receiver can be extended by using the one of the optional cable kits listed above. Note: These cables replace the 25’ cable supplied with the antenna, and must be used as supplied. They cannot be lengthened, shortened, or connected together as extensions.

Electronic Products Group

6111Shakespeare Rd., Columbia, SC 29223 · 803-227-1590 · Fax: 803-419-3099

www.shakespeare-marine.com

©2005 Shakespeare Co. all rights reserved

 

“Sirius” and related marks are trademarks of Sirius Satellite Radio, Inc.

rev. 12-07-2006

Image 6
Contents Important Please read all instructions before installing Galaxy Style SRA-40Shakespeare Galaxy Style SRA-40 Satellite Radio Knife-slit for passage of cable Cable and connector Firm up the mounting screws, but do not over tightenPedestal Mounting Follow Steps 2 through 5 above. ThenSurface Mounting Completing the installation Extension Mast or Rail MountingOptional Accessories SRS-1