Use an
receiver of a wireless microphone) to the audio input INPUT . |
|
Audiobeam automatically emits ultrasound as soon as | an audio signal (see |
“Specifications”‘ on page 6) is present at the audio input INPUT .
Use the mains cable to connect Audiobeam to the mains. Secure the mains cable with the steel clamp .
The LED operation indicator lights up green, indicating that Audiobeam is ready for operation (standby).
Note: If you do not use the unit for a period, disconnet the mains connector from the wall socket. This helps to increase the service life of Audiobeam and save energy.
Troubleshooting
If the LED operation indicator | lights up red, one of the following problems may have |
occured: |
|
On/off switch for distance sensor is activated
Someone has entered the security area of four meters in front of or around the Audiobeam and the motion sensor has triggered. After the person has left this area, Audiobeam automatically turns on again after 30 seconds.
Solution: Set the on/off switch for the distance sensor | to “off”. |
Audiobeam is defective
Please contact your Sennheiser distributor or the Sennheiser Service department (for address, see last page).
Accessories
The following accessories are available from your Sennheiser distributor:
GZP 10 Mounting plate for wall and ceiling mounting
GZG 1029 Swivel joint for attachment to stands or the GZP 10 mounting plate, includes 1/4" interchangeable thread
MZT 14 Mounting bolt for mounting goosenecks and swivel joints with 3/8" thread to table tops MZT 100 Stable, metal table stand with 3/8" thread
MZT 1019 Mounting bar for two units with 3/8" internal thread SEMS 3134 Floor stand with 3/8" thread
5