Presetting stations in AM/FM mode
There are 6 preset stations each for AM and FM radio. They are used in the same way for each waveband.
1.Press the Standby button to switch on your radio.
2.Press the Source button to select the desired waveband. Tune to the required radio station as previously described.
3.Press and hold the required Preset button (1 to 6) until the display shows “P3” for example after the frequency. The station will be stored using the preset number. Repeat this procedure for the remaining presets as you wish.
4.Preset stations which have already been stored may be overwritten by following the above procedure if required.
Recalling a preset in AM/FM mode
1.Press the Standby button to switch on your radio.
2.Select the required waveband by pressing the Source button.
3.Momentarily press the required Preset button to cause your radio to tune to one of the stations stored in the preset memory.
Note:
the remote control can only recall preset stations. Presetting stations can’t be operated by remote control.
2
3
GB
18