Sangean Electronics ATS-606A manual Band Selection, Band Frequency Program Type

Page 21

BAND SELECTION

There are four band selector buttons located just beneath the LCD display.

-STANDBY-

		LW		MW
ATS		ATS		ATS

TIMER

SW

METER

BAND	FREQUENCY		PROGRAM TYPE
FM	87.5-108	MHz	Standard FM
LW	153-513	kHz	Longwave
MW	520-1710	kHz	Standard AM
SW	1.711-29.999	MHz	SW/13 sub-bands

20

Image 21

Contents Page Contents Features Control Locations ATS606A Volume 26 25 Display Information Using Batteries Choosing a Power SupplyOpen Press Usinghousecurrentacadaptor Battery Replacemen TTime to Replace Batteries Page Setting the Clock Preliminary SettingsWhile SET is flashing ,set the correct time Setting Dual Time Page Numbers will show up on the LCD display Standby ATS Zero Second SET Band Frequency Program Type Band SelectionQuency selected Meter.i.e 7.100 Mhz Adjusting the Antenna Tuning ModeTelescopic Direct Tuning 7,0, That exact frequency Adjust the Volume control for comfortable listening Manual Tuning Press the POWER/SLEEP button to turn on Radio Tuning Memory Scan Scan Tuning Adjust antenna or radio position depending on Selected band Adjust Volume control for comfortable listening Storing a Frequency Memory TuningTime SET 2 3 4 5 6 7 8 But Recalling a Preset Cancelling Preset Exchange the Preset Push 7 then preset 2 and preset 7 have been exchanged ATS Auto Tuning System Page 2 3 4 Fine Tuning Clock Radio Operation Setting the Alarm StandbySetting Alarmstandbyby Radio Display will show 1330 and Standby will To verify, press Standby button then Enter button again Setting Alarm by HWS Buzzer Counting Down Timer Use 0-9 button to key in required time Max Sleep button Timer Meter Setting the Sleep Timer 3 4 5 Miscellaneous Controls Mono LOCAL/STEREO DX SwitchHeadphone USE External Antennause Lock SwitchMW Step Selector Switch AR E AN D M AI N T E N AN C E Page Page Frequency range SpecificationsSemi conductors