OPTIMUS
XTS 36 MINI SPEAKER | Cat. No. |
SPECIFICATIONS | |
Frequency Response | 140 Hz— 20 kHz |
Power Handling | 15 watts (RMS) |
Maximum Power | 30 watts |
Impedance | 8 Ω |
Speaker Complement | 3” (7.62 cm) full range |
Enclosure: | Sealed high density plastic cabinet for |
| extended bass response |
Dimensions: | 55/8 ¥ 39/16 ¥ 3 3/8 Inches (HWD) |
| (14.2 × 9.0 × 8.5 cm ) |
Shipping Weight: | 1.4 lbs. (0.6 kg) |
CONNECTING THE SPEAKER
You need speaker wire (not supplied) to con- nect the speaker to your receiver or amplifier. We recommend you use wire that is
Note: For maximum bass response and the best overall performance, be sure the polarities match when you connect the speaker to the re- ceiver or amplifier (positive to positive and neg- ative to negative).
1.With the speaker in its appropriate loca- tion, measure the distance from the speaker to the receiver or amplifier. Then route the proper length of speaker wire from the speaker to the receiver or ampli- fier.
Cautions:
•Avoid routing the speaker wire near other electrical wires.
•Do not nail or staple the speaker wire.
2.Split apart 4 inches of speaker wire on each end.
3.Strip 1/4 inch of insulation from each wire’s end. Then twist the ends of the wire to secure any loose strands.
1/4 | Inch |
| |
Speaker Wires |
|
Inches | |
4 |
|
4.While pressing and holding down the black (negative) terminal tab on the back of the speaker, insert one end of the negative bare wire into the opening. Then release the tab.
© 1995 Tandy Corporation.
All Rights Reserved.
Optimus and Radio Shack are registered trademarks used by Tandy Corporation.