Musical Fidelity V-LPSII specifications Introduction, Installation Precautions, Power Supply Note

V-LPSIIPhono Stage

Instructions

Introduction

Thank you for purchasing the V-LPSII. We sincerely hope that it will bring you many years of outstanding listening pleasure.

Installation Precautions

Your new V-LPSIIis designed and built to provide trouble-free performance, but as with all electronic devices, it is necessary to observe a few precautions:

Do not use the V-LPSIInear water. The unit must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, must be placed on the unit.

Keep the V-LPSIIaway from heat such as radiators. No naked flame sources, such as lighted candles, should be placed on the unit.

Power Supply Note:

Only use approved Musical Fidelity DC power supply. The use of other adaptors or supplies could seriously damage the V-LPSII

.

This Hi-fi product has been tested to ensure that its operation is not adversely affected by normal background levels of Radio Frequency Interference (R.F.I.), and that it does not itself generate excessive amounts of interference. However, if a problem persists, please contact your Musical Fidelity agent.

Never open the case of the V-LPSIIyourself, as this will invalidate the guarantee.

Place all connecting cables where they are not likely to be walked on or trapped by items placed on them.

The V-LPSIIwill operate in accordance with its specifications within the following environmental range:

Temperature 5 to 45 degrees Celsius Humidity 10 to 90% non condensing

There are no user adjustments inside. Please refer all service work to an authorised Musical Fidelity agent.

Connections

All connections must be made before the mains adaptor is plugged in, and before any amplifier connected is switched on. Always switch off the equipment attached to the V- LPSII before connecting/disconnecting power, changing leads or inputs.

Inputs

Using good quality RCA leads (not supplied), connect the left and right turntable outputs to the correct V-LPSIIINPUT sockets.

Use the phono MM input for moving magnet cartridges. Make sure MM/MC switch is OUT.

Use the phono MC input for moving coil cartridges. Make sure MM/MC switch is IN. An earthing terminal is provided. Connect earth wire from turntable to this terminal if hum is apparent. Other setups may work fine with this terminal left disconnected and no harm is done in doing so.

Outputs

Connect the V-LPSIIleft and right OUTPUTS to the desired LINE LEVEL (e.g AUX) inputs of the amplifier system.

Power

Plug the DC connector lead from the power supply unit into the V-LPSIIpower inlet socket, and plug the adaptor itself into a convenient wall mains outlet. The blue LED will light to confirm the unit is ready for use.

Use

Turn the volume on amplifier to normal listening levels, sit back and enjoy the music. These products have been designed so that it may be left on indefinitely, but please note that the mains adapter may become warm to the touch - this is normal.

Front and back connections

Moving magnet (MM)/moving coil (MC) input select switch	Power input socket
4mm earth terminal	Power LED

Left (white) & right (red) RCA moving coil (MC) inputs	Left (white) & right (red) RCA line outputs
Left (white) & right (red) RCA moving magnet (MM) inputs