CR1100.O/M.QXD 4/16/02 3:51 PM Page 6
INSTALLATION
Unravel the AC cord and connect it to a conveniently located AC outlet having 120V
and 60Hz only. The Clock Display will illuminate and “12:00” will blink in the window. NOTE: If the AC plug does not fit into a
nonpolarized outlet, do not file or cut the wide
blade. If the AC plug does not fit into a nonpolarized AC outlet, do not file or cut the
wide blade. It is the user’s responsibility to have an electrician replace the obsolete outlet.
If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended).
Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting it again two or three minutes later. The preset times should continue operating. If the present time does not appear, it indicates the battery is dead or not connected properly. The 9 volt battery will keep the internal times accurately for approximately 30 minutes. If the power is restored after 30 minutes, the times may need to be reset.
9V
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.Use only the size and type of battery specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.
3.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
4.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)
6