OPERATING INSTRUCTIONS Powering Up
Plug the AC power cord into a 120V, 60Hz electrical outlet. The clock display will light up and flash indicating the power is on.
NOTE: This cord is polarized. This means the cord will only fit one way into the socket or wall outlet. If it does not fit, do not force it, just reverse it and try again.
BATTERY BACK-UP
If the AC cord is disconnected or if there is a short time power failure, this electronic clock and timer are designed to continue operating internally (without showing in the display) if a 9 volt battery (not included) is installed.
The radio will work fine without this back up battery.
NOTE: You may check the condition of the battery every few months by disconnecting the AC cord and connecting it again 2 or 3 minutes later. The preset times will show. If the time flashes, it indicates the battery is dead or not connected properly.
Setting the Clock
1.Press the TIME set button together with the HOUR set button until the display shows the desired hour.
2.Press the TIME set button together with the MINUTE set button until the display shows the desired minutes.
NOTE: When the PM indicator is off, the time is AM.
Setting the Alarm Time
1.Use the ALARM/OFF button to check the alarm time.
2.Press the ALARM/OFF button together with the HOUR set button until the display shows the desired alarm hour time.
3.Press the ALARM/OFF button together with the MINUTE set button until the display shows the correct alarm minutes.
4.Make sure the PM lamp is off if you want the clock to wake you in the morning.
5.Release the ALARM/OFF button, the clock display will show the normal time of day.
NOTE: Again check the PM indicator. If you want the radio to wake you in the morning, the lamp next to PM should be off on alarm time (when pressing ALARM/OFF button). To change PM to AM time, advance time 12 hours. To have clock wake you up, slide the FUNCTION switch to AUTO or ALARM position(s).
Playing the Radio
1.Slide the FUNCTION switch to ON position.
2.Slide the BAND switch to either AM or FM.
3.Turn the TUNING control to your desired station.
4.Adjust the VOLUME control to your favorite listening level.
5.Slide the FUNCTION switch to OFF position to shut off the radio.
GETTING BETTER RADIO RECEPTION:
For best AM reception, rotate the radio a small amount or position it near the window.
For best FM reception, unwrap and fully extend the FM antenna wire. WARNING: Do not connect the FM antenna to an outdoor antenna.
4