Lenoxx Electronics PDV-702 instruction manual Playing a Disc

Page 10

1. PLAYING A DISC

1 Lift the LCD screen.

2 Slide the DVD player’s POWER switch to the ON position, the DVD logo (start-up picture) will appear on the screen.

3 Press the OPEN button on the DVD player to open the disc door. Place a disc gently on the tray with the label side up, make sure the disc is seated on the spindle by pressing down in the

center, then close the door. The DVD player starts to read the

disc’s table of contents (this may take a few seconds).

NOTE 1: Load the disc with the label side facing up, when

playing a double-sided disc, load it with the desired

playing side face down.

NOTE 2: “NO DISC” will show in the display if the disc is upside down or the disc is badly scratched or dirty, it will not play. Please clean it or change the disc before use. Also you can buy a disc polisher to try to repair the scratched disc.

4 Some discs will start playing automatically, and others will display the disc contents menu on the screen. If the menu is shown, use the (, , & ) direction buttons to highlight your selection and press the OK button to confirm, otherwise you may press play.

5 Press the VOLUME + or VOLUME – button to adjust the volume level.

6 Press the BRIGHTNESS and COLOR buttons to adjust the brightness and the color of the LCD screen if needed.

7 To stop playback, press the STOP button.

8 To pause the playback, press the PLAY/PAUSE button. To resume playback, press the PLAY/PAUSE button again.

NOTE 1: During play, pressing the STOP button once will show “PRE STOP ” in the display, if you press the STOP button the second time, the display will show

“STOP ”, and now your system is in the full STOP mode.

NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same as during normal play, remember to shut off the power after use.

9 To skip to another track/chapter, press the NEXT

 

or PREVIOUS

button repeatedly

 

 

during playback.

 

 

 

10 To access the disc menu or title menu during DVD play, press the MENU or TITLE button.

11 Remember to shut off the player by sliding the POWER switch to the OFF position when the movie finishes playing.

NOTE: This player has a screen saver which will display a bouncing DVD logo if no video is played for a while.

9

IB-PDV702-WM-E-010807

IB-PDV702-WM-E-010807.pmd

10

 

 

1/30/2007, 7:12 PM

 

 

 

 

 

Image 10
Contents Portable DVD Player Safety Instructions Blade Plug to Wide SLOT, Fully InsertIncluded Accessories FCC NoteTable of Contents Controls Overview Front ViewRechargeable Battery For DC power supply Rechargeable BatteryRight Side View Using the AC adaptor Power SupplyUsing the car adaptor Detaching the Battery Using the rechargeable batteryAttaching the Battery To charge the batteryDiscs that can be played Discs that cannot be playedPlaying a Disc Changing Subtitle Language DVD only Using the Search FunctionSelecting Audio Mode Search through a chapter or a trackFor CD Play Displaying Disc InformationFor DVD Play For MP3 PlayJust for DVD Repeat PlaySLOW-MOTION Play For CDFor DVD Zoom Play for DVDSearch for Preferred Play For CD10. MP3 Disc Operation Jpeg or Picture Disc OperationConnecting the DVD player to your TV Using the attached Audio and Video cablesConnecting to your headphones headphones are not included Connecting to a digital home theater systemHow to Find your TV’s Video Input Channel Watching a DVD on Your TVYou can get to the Setup menu by following the below steps Initial Setting For TV or Portable UseSystem Setup TV SYSTEM, LCD MODE, TV Type & Default Setting the LCD ModeLCD Mode Initial SettingDefault Resetting the functions to factory defaults Selecting the TV TypeVideo Setup Language Setup On Screen Display, AUDIO, Subtitle & MenuSpeaker Setup Downmix Precautions Symptom Remedy Trouble ShootingGeneral Symptom Remedy General Symptom DVDGlossary About DVD Region ManagementGeneral Description SpecificationsAudio Signal Output Characteristics DVD linear audioFor Customer Service Dial