JBL CONTROL NOW manual Stand-Mounting, Important Safety Note, Speakers have coded terminals that

STAND-MOUNTING

IMPORTANT SAFETY NOTE:

CAUTION

The supplied floor stand adapters facilitate installation with a variety of general- purpose floor stands available from many manufacturers. Since different stands will have different weight capacities and stability characteristics, it is the customer’s responsibility to check with the stand manufacturer or dealer to ascertain whether that specific stand is capable of handling the weight and proportions of these loudspeakers in a safe and stable manner. JBL, Inc., disclaims any liability for the selection of suitable floor stands and/or correct compatibility between the selected stand and the supplied stand adapter.

IMPORTANT: Make sure all equipment is turned off before making

any connections. For speaker connections, use a high-quality speaker wire with polarity coding. The side of the wire with a ridge or other coding is usually considered positive polarity (i.e., +).

NOTE: If desired, consult your local JBL dealer about speaker wire and connection options.

1.	Strip 1/4" of wire	The speakers have coded terminals that
		accept a variety of wire connectors. The most
2.	Press and push connector
		common connection is shown in the diagram
3.	Insert bare end;
	release push connector	to the left. To ensure proper polarity, connect
	BLACK = —	each + terminal on the back of the amplifier
RED = +		or receiver to the respective + (red) terminal
		on each speaker, as shown. Connect the

Note trough in Stand-Mount Bracket for

cable management.

#1/4-20 x 1" Screw Provided

Stand-Mount Bracket

1.Attach the stand-mounting bracket to the stand with the #1/4-20 x 1" screw as shown.

2.Run the wiring as shown.

– (black) terminals in a similar way. See

the owner’s guides that were included with

your amplifier, receiver and television to

confirm connection procedures.

IMPORTANT: Do not reverse polarities (i.e., + to – or – to +) when making connections. Doing so will cause poor imaging and diminished bass response.

Standard

Connection

Wiring diagram shows polarity connections for

Stand

one channel of a stereo or

RED = + BLACK = — home theater system.

3.Place the JBL Control NOW speaker on the stand-mount bracket and stand, as shown.

An alternate orientation shown here.

4.Use two #8-32 x 1/2" screws provided to secure the JBL Control NOW speaker to the stand.

5.Attach wires.

#8-32 x 1/2" Screws

17