JBL j50 owner manual Introduction, Placement

Page 2

INTRODUCTION

Congratulations on choosing JBL

J Series Loudspeakers. Their highly accurate, uncolored and balanced sound character will greatly increase your enjoyment of recorded music and movies. JBL speakers are built with careful attention to detail, using only the highest quality materials. They will provide many years of excellent performance.

The J Series is the result of combin- ing traditional JBL Signature Sound performance values with elegant contemporary appearance.

Maximum Cone Surface Area: The J Series transducers have been designed to maximize the cone surface area, a technology that allows for shorter excursion of the driver without sacrificing critical air movement.

Maximum Efficiency: Larger air movement coupled with shorter coil movement allows the J transducers to be very efficient. See specifications.

Maximum Transducer Control: Reduces distortion by tightening the control of driver excursion and increasing driver linearity.

Smooth, Accurate, Extended Response: The J Series transducers, computer-optimized dividing net- works, and bass reflex cabinets com- bine to give clear, crisp, accurate, JBL Signature Sound.

PLACEMENT

Bookshelf Models: For the best stereo reproduction, the two loud- speaker systems should be an equal distance from your listening position and separated so that the angle

between them, at the listening posi- tion, is between 40 and 60 degrees (see Fig. 1). For example, if your lis- tening position is 8 to 12 feet (2.5m to 4m) from each speaker, the two systems should be about 8 feet (2.5m) apart. Placing the loudspeak- ers in corners or against a wall will result in the strongest (not necessa- rily the most accurate) bass. Except for the J50, all J Series speakers have their ports in the front so you can place the rear of the speaker up against a wall. In the case of the J50, do not place the speaker closer than 3 inches (75mm) to the wall behind it if possible.

For the best stereo imaging, we rec- ommend that the systems be placed so that the high frequency transduc- ers are positioned approximately at ear level of a seated listener. Every room is different and there are differ- ent tastes, so don’t hesitate to experi- ment on your own.

40°-60°

Fig. 1

Tower Models: The Tower models cabinet height and driver placement allow for speaker placement directly on the floor. For the best stereo reproduction, the two loudspeaker systems should be an equal distance from your listening position and sepa- rated so that the angle between

2

Image 2
Contents R I E S Placement IntroductionPreparing the Hookup Wire ConnectionsHooking Up Multiple Sets of Speakers Nominal impedancePower Handling TroubleshootingGeneral Care ServiceAdditional Areas to Check When Using an AV Receiver Specifications Center J50 J520M J620M Specifications J820M J830M J900MII