Roadmaster VRFM9BT specifications Installation & Operation, Remote Control, Specifications

Blue Tooth

Pair ing

VRFM9BT

Installation & Operation

INSTALLATION

Remote Control

CH Button

Dear Customer,

CONGRATULATIONS. The VRFM9BT Hands Free Bluetooth Car Kit MP3/WMA player & FM modulator, when used as described, will give you years of dependable service in your car, truck, RV, or mini-van. We have taken numerous measures in quality control to ensure that your prod- uct arrives in top condition and will perform to your satisfaction. In the rare event that your VRFM9BT Hands Free Bluetooth Car Kit MP3/WMA player & FM modulator contains a dam- aged or missing item, does not perform as specified, requires warranty service, or you have an installation problem, DO NOT RETURN THIS PRODUCT TO THE STORE. PLEASE CALL OUR TOLL FREE NUMBER FROM THE U.S.A. AND CANADA 1-800-445-1797and ask to speak with a member of our technical service team, or submit your questions by e-mail to custom- erservice@vr-3.com and a member of our technical service team will respond by e-mail to your questions. Our in-house technical service team will expedite delivery of your part, advise you

1.Insert the VRFM9BT into the vehicle’s 12 Volt cigarette lighter socket or 12 Volt power outlet.

2.Adjust the VRFM9BT’s transmitting frequency to an FM channel between 88.1~108.0MHz that is not being used by any local radio stations.

3.Set your vehicle’s FM radio to the same channel as the VRFM9BT.

4.The VRFM9BT is now ready to be paired with a Bluetooth enabled cell phone, transmit music played from a USB or SD/MMC memory or other audio source through the line-in.

BLUETOOTH

The VRFM9BT will not enable your cell phone to have features it does not already have. For ex- ample: If your cell phone does not support A2DP music streaming, then pairing your cell phone with the VRFM9BT will not enable your phone to stream music. See your cell phone’s manual to see your cell phone’s built-in Bluetooth features.

Pairing the VRFM9BT with a Bluetooth enabled cell phone

Turn your cell phone’s Bluetooth Function ON.

EQ Button

Call Switch

Play/Pause

Answer/Pairing

Previous Track &

Volume Down

Microphone (MIC) Mute

CH+ / Next Folder

Voice Dial

Next Track & Volume Up

RED Button (re-dial)

CH- / Previous Folder

Number Buttons

on installation, or help troubleshoot a problem with you. If your product needs warranty service, our technical service team representative will help you obtain the fastest remedy possible under the warranty.

Specifications

Full Duplex Communication
DSP (Digital Signal Processing) Technology
Bluetooth interface	Version 1.2, Class 2,
Bluetooth frequency range:	2.402 ~ 2.480GHz
Supported BT Profiles:	HSHF, Headset, A2DP,
Supported File Formats	MP3 & WMA
FM transmitting range:	88.1~108.0MHz
Operating voltage range:	DC 12V~24V
Current	2 amps
USB Charger Output Rating:	5V DC, 500 ma
Support:	SD/MMC, USB
Display:	1.5”LCD, 128*128 pixel
Audio In:	3.5mm
Features & Functions

•Bluetooth car kit, compatible with all Bluetooth phones.

•CVC technology to eliminate noise and restrain echo, enjoy crystal clear sound.

•Supports Line-in, USB & SD/MMC,

•Streams music from the phone to the VRFM9BT via Bluetooth.

•Wide LCD display, supports full frequency transmitting (88.1-108.0Hz)

•EQ Mode and Repeat Mode Options.

•Supports Last Number Re-Dial and Voice Dialing

•Mute function for Private Conversations.

•Automatic Re-Connection.

• Built-in Microphone.	Microphone	RED Button(Re-dial)
LCD Screen
		Control Panel
Auxiliary Input
		USB Port and
		SD/MMC Card Slot

1. Insert the VRFM9BT into the vehicle’s 12 Volt cigarette lighter socket or 12 Volt power outlet. If your cell phone receives a pairing request from the VRFM9BT, then skip step 2 and go to step 3.

2. Press and hold the PLAY button on the control panel or on the remote control for 3 seconds, “Pairing” will be displayed on the screen indicat- ing that the unit is ready to be paired.

3.Follow your cell phone’s instructions for searching for a new device and pairing, when asked select “VRFM9BT” from the list of device’s, then enter the passcode “0000” and confirm.

If you are using a “dongle” type Bluetooth adaptor; follow the manufacturer’s instruc- tions for that device.

4.If pairing is successful, then “Pair OK” will be displayed the screen of VRFM9BT, and the Bluetooth icon will be shown on the screen.

USB PORT & SD/MMC SLOT

The USB port and SD/MMC card slot are used to play MP3 and WMA files from USB memory and SD/MC cards that are not protected by Digital Rights Management(DRM).

The USB port can also be used to charge most electronic devices that uses a USB cable for charging.

CONTROL PANEL

USB Port

SD/MMC Card Slot

EQ Button

PLAY/PAUSE/PAIRING BUTTON

/

PREVIOUS & NEXT BUTTONS

Pairing – Press and hold for

Change the Song

3 seconds, “Pairing” is dis-

played on the screen.

Press the

button to change

Answer a Call – Press once to

to previous song.

answer a call.

Press the

button to change

Play – Press once to play

to next song.

the music under the playing

mode.

Change the Volume

Pause – Press once to pause

Press and hold the

button

the music.

to lower the volume.

B+ / A- BUTTONS

Press and hold the

button to raise the

volume.

The

B+

and A-

buttons

RED Button (Re-dial)

change

the FM frequency

(VRFM9BT must be paired with a Bluetooth

while in USB/SD/MMC or Aux

cell phone)

In mode, or they change the

folder

your music is

played

Last Number Re-dial

from.

Press and hold the RED button to re-dial the

Change the Frequency

last number dialed out.

Press “B+” to advance to the

End or Reject a Call

next frequency.

Press “A-” to go to the previ-

Press and hold the RED button to end or re-

ous frequency.

ject an incoming call.

EQ Button

Changes the EQ Pre-set or the repeat mode. Change EQ mode

Press the EQ button to change the EQ mode as follows: Normal > Rock > Pop > Classi- cal> Live.

Change Repeat mode

Press and hold the EQ button to change the Repeat mode: ALL > SINGLE > FOLDER >

NORMAL > RANDOM.

CH Button

Press the CH button while in playback mode to change the frequency the unit is tranmit- ting on by entering the frequency with the number buttons of the remote control, or with the CH+/CH- buttons.

CH+ / CH- Buttons

The CH+/CH- buttons change the FM fre- quency or the file folder.

To change the FM frequency

Press “CH+” to advance to the next frequency. Press “CH-” to go to the previous frequency.

To change the Folder

Press and hold the CH+ button to change to the next folder.

Press and hold the CH- button to change to the previous folder.

Microphone Mute Button

Mutes the VRFM9BT’s microphone when you are talking on the phone.

Press the Mute button once to mute the mi- crophone, press it again to return to normal operation.

Play Button

Play / Pause / Answer / Pairing

In Playback mode

Press the button to start.

Press the button to pause playback.

In Bluetooth Mode Pairing

Press and hold the button for 3 seconds

to enter Pairing Mode, and “Pairing” is dis- played on the screen.

Answer a Call

Press the button to answer a call under speaking mode.

& Previous & Next Buttons

Changes the track or volume

To change the track

Press the button to change to the previous track. Press the button to change to the next track.

To adjust the volume

Press and hold the button to decrease the volume.

Press and hold the button to increase the volume.

Red Button

VRFM9BT must be paired with a Bluetooth cell phone.

Last number re-dial

Press and hold the Red button to re-dial the last number dialed out.

End or reject a call – Press and hold the Red button to end or reject a call.

Call Switch Button

To transfer a call from the VRFM9BT to your cell phone.

Press the Call Switch button once to trans- fer the call between VRFM9BT and your cell phone.

Voice Dialing Button

Your cell phone must support Voice Dialing. Press the Red button to enable your phones Voice Commands for Voice Dialing.

Number Buttons

Use the Number buttons to enter the FM channels.

Press the CH button, then enter the number for the frequency the VRFM9BT to transmit on.

(Not Shown)

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol- lowing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Change the Folder	Transfer a Call
Press and hold the “B+” to
	While speaking on the cell phone, press the
change to the next folder.
	RED button to transfer the call from the cell
Press and hold the “A-” to
	phone to the VFM9BT.
change to last folder or next

folder.

GIVE US A CALL, WE'LL HELP YOU INSTALL.

PLEASE DO NOT RETURN PRODUCT TO STORE.

Visit us on the WEB

www.vr-3.com

For Information and Technical Assistance,

Call Toll-Free in U.S.A. and Canada.

1-800-445-1797