5.Attach the Top Stand (4) to the Vertical Stand (2) and Middle Stand (3).
(See Assy. Diagram.)
6.Carefully set the Large Bowl (5) on the Bottom Stand (1). (See Assy. Diagram.)
7.Carefully set three Small Bowls (6) on the Middle Stand (3) and Top Stand (4).
(See Assy. Diagram.)
8.Carefully set the Jug (7) on the Top Stand (4). (See Assy. Diagram.)
9.Route the Hose (8) downward into the Large Bowl (5). (See Assy. Diagram.)
10.Set the Pump (9) in the middle of the Large Bowl (5). (See Assy. Diagram.)
11.Connect the Hose (8) to the Pump (9). (See Assy. Diagram.)
12.Make sure the Fountain is unplugged from its electrical outlet. Then, move the Flow Regulator of the Pump (9) towards the “+” position. NOTE: After running the Fountain, it may be necessary to adjust the rate of water flow. If so, disconnect the Pump from its electrical outlet. Moving the Flow Regulator towards the “+” position increases the rate of flow. Moving the Flow Regulator towards the
13.Fill the Large Bowl (5) with a minimum 2” of water. Do not overfill the Large Bowl. (See Assy. Diagram and Figure F.)
MINIMUM WATER LEVEL
PUMP (9) |
| FOR BEST RESULTS, |
| COMPLETELY SUBMERGE THE PUMP. | |
|
|
FLOW
REGULATOR
FIGURE F
SKU 93442 | For technical questions, please call | PAGE 10 |