Troubleshooting

Warning

If your Jukebox with CD Player does not turn on, make sure that it is properly plugged in to a functional electrical outlet.

If your radio doesn’t work properly, try one of the following solutions.

The AM/FM knob isn’t turned far enough in either direction. Turn the knob all the way to the left or right.

The volume is too low. Turn the VOLUME knob clockwise to increase the volume.

The radio isn’t tuned to a station. Rotate the tuning knob until you find your desired radio station.

If there is a lot of distortion in your radio signal, try one of the following solutions.

Move the radio to a different location.

If your CD player doesn’t work properly, try one of the following solutions.

Reload the disc so the label is facing up or carefully clean the disc with a soft dry cloth.

•The lightning flash symbol within the black triangle represents a warning. This unit contains un-insulated dangerous voltage which may be of significant magnitude to cause an electric shock.

•This unit uses a laser.

•Use of any controls, adjustment or procedures other than those specified within this manual, may result in hazardous radiation

exposure.

•To reduce the risk of electric shock, do not remove the front or back cover.

•To prevent fire or shock, do not expose this appliance to rain or moisture.

•To prevent electric shock, match the wider side of the electric plug to the wider entrance of the electric socket, making sure to fully plug the electric plug into the socket.

•When placing the unit, do not place the unit in humid,

hot, cold, or dusty conditions; place the unit on a flat and even surface; do not cover the unit with a cloth or place it against something that may restrict air flow.

•When disconnecting or disconnecting the electric cord, grip the plug, not the cord. If you pull from the cord, you could damage it.

•If you are not going to use it for a long period of time, disconnect the plug from the electric socket.

•If you leave your unit in a humid place, water droplets and con densation may form inside the unit. If there is condensation inside the unit, it may not function properly. Let the unit stand for one to two hours to allow the unit to dry before using the unit.

•Should you experience any trouble, disconnect the electric cord and bring your unit to a qualified technician.