Surface Mounting

NOTE: To remove the trim ring from the tweeter housing:

1.Rotate the trim ring a few degrees in a clockwise direction until you feel a detent.

2.Remove the trim ring by lifting it straight up.

INSTALLING THE TWEETER

Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.

Step 2: Place the surface mount housing against the panel and mark the two holes at the rear of the housing.

Step 3: Drill the smaller center hole using a 1/8" drill bit. This is the mounting screw hole.

Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet and route the speaker wire from the crossover through the grommet.

Step 5: After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover.

Step 6: Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting.

Step 7: Attach the housing using the supplied screws of the correct length for a solid mount.

Step 8: Insert the tweeter into the housing and attach the trim ring.