against the panel and mark the two holes at the rear of the housing.
3.Drill the smaller center hole using a 1/8" drill bit. This is the mounting screw hole.
4.Drill the larger
8.Insert the tweeter into the housing and attach the trim ring.
Removing Trim Rings
Hold the tweeter housing while gently turning the trim ring in a clockwise direc- tion until it releases. The trim ring can then be easily lifted away from the tweeter housing.
5.After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover. (See Figure 5.)
6.Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting.
7.Attach the housing using the supplied screws of the correct length for a solid mount.
Installing Trim Rings
Flush Mount Assembly - With the arrow in the tweeter housing facing up, place the trim ring into the housing with the Directed logo at the bottom and turn in a counter clock- wise direction until the trim ring clicks into place.
Surface Mount Assembly - Insert the trim ring into the housing and turn in a counter clockwise direction until the trim ring clicks into place.
FIGURE 2—FLUSH MOUNTING REMOVED PANELS
FLUSH MOUNT TWEETER ASSEMBLY
PRESSURE RING
TWEETER WIRE
WIRING HARNESS
8 | © 2003 Directed Electronics, Inc |