Philips EXP201, EXP203 IN-CAR Connection, In-car use connections supplied or optionally available

Page 12

IN-CAR CONNECTION

English

In-car use (connections supplied or optionally available)

	Only use the AY 3545 car
	voltage converter (4.5 V, DC,	12 V DC
	positive pole to the center	12 V DC
	positive pole to the center
	pin) and the AY 3501 car
	cassette adapter. Any other
	product may damage the set.
	1 Put the CD player on a
	horizontal, vibration-free and
	stable surface. Make sure it	4.5 V DC
	is a safe place, where the	4.5 V DC
	is a safe place, where the
	player is not a danger or

obstacle to the driver and passengers.

2Insert the voltage converter into the cigarette lighter socket. If necessary, clean the cigarette lighter socket to obtain a good electrical contact. (only for a 12 V car battery, negative grounding).

3Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD player.

4Turn down the volume and connect the cassette adapter plug to the LINE OUT / p of the CD player.

5Carefully insert the cassette adapter into the car radio’s cassette compartment.

6Make sure the cord does not hinder your driving.

7Start the CD player, set VOL E to position 8 and adjust the sound with the car radio controls.

•Always remove the voltage converter from the cigarette lighter jack when the CD player is not in use.

Notes: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a parked car in the summer).

–If your car radio has a LINE IN jack, use the LINE IN jack for the car radio connection instead of the cassette adapter. Connect the signal lead to this LINE IN jack and the LINE OUT / p jack of the CD player.

12

Image 12

Contents AudioAudio Ssaaffeettyy symbols PEN Lineout Important Safety Instructions Remove batteries when the unit is not used for a long timeEnglish FrançaisEspañol CONTROLS, refer to the illustration on Locks all buttonsQuick Start PlayPower Supply Power adapter supplied or optionally available Only use the AY 3160 power adapter Line out Headphones and Sound Options Headphones HLVolume and sound adjustment DBB Dynamic bass boost and Audible beep feedbackMP3-CD player and CD handling Environmental informationDo not touch the lens a of the CD player Avoid dropping the set as this may cause damageIN-CAR Connection In-car use connections supplied or optionally availableOnly use the AY 3545 car Voltage converter 4.5 V, DC Positive pole to the centerFeatures Selecting a track / title and searching CD and MP3MP3 quick search on MP3-CDs only Programming track/title numbers You can select up to 32 titles and store themMemory in a desired sequence. You can store any Or ¢To deactivate HOLD, switch the slider to OFF Storing the last position played ResumeLocking all buttons Hold Damage caused by dropping Activation Belt Clip not on all versionsSelecting different playing options Mode DBBToggle 38 to switch on the set, start playback or pause CD PlayPlaying a CD Lid opensPlayback information How to get MP3 music MP3-CD PlaybackGeneral Information Supported formatsHow to organize the MP3 ﬁles Visit the Expanium homepageGeneral information on Writing Formats There are 3 formats used to record data on a discDAO Disc At Once MultisessionTo play MP3-CDs Insert an audio CD, printed side up, by pressingMaximum 40, and titles maximum Press 38 to start playback Press 7 to stop playbackTroubleshooting Symptom Check point TreatmentPlayback does Not start fromFirst track Sound qualityLimited Warranty Exchanging a Product in Canada