Philips AJ3225 user manual Troubleshooting, Problem, No sound/power, Alarm does not function

Page 9

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock.

Problem

Possible Cause

• Remedy

No sound/power

Volume not adjusted

• Adjust the volume

Occasional crackling sound during FM broadcast

Weak signal

• Extend and position the pigtail

Continuous crackling/hiss disturbance during MW (AM/LW) broadcast

Electrical interference from TV, computer, fluorescent lamp, etc.

• Move set away from other electrical equipment

The alarm does not function

Alarm time not set and/or alarm mode not selected

• See the alarm time and / select alarm mode

Volume too low for RADIO

• Adjust the volume

Radio alarm not adjusted to radio station

• Tune to a radio station

Image 9
Contents Clock Radio Page Sleep OFF /REPEAT Alarm Alarm 1 , AlarmControls Clock Memory Backup Installation Power SupplySelecting the Alarm Mode General Setting the Clock and Alarm TimesRadio To improve receptionHour Alarm Reset Switching OFF the AlarmCanceling the Alarm Completely Repeat AlarmYear Free Repair Service at Philips ASC Environmental Information Safety & Maintenance InformationProblem TroubleshootingNo sound/power Alarm does not functionConditions NEW Zealand Guarantee and Service for New ZealandAJ 3225 Clock radio