Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Do not open the set as there is a risk of electric shock. Under no circum- stances should you try to repair the set yourself, as this will invalidate the warranty.
No sound.
–Volume not adjusted.
• Adjust the VOLUME.
Display error / no reaction to any controls.
– Electrical malfunction
•Press RESET hole on the bottom of the set with a ball pen.
Occasional crackling sound during FM broadcast.
– Weak signal.
• Extend the pigtail antenna fully.
The alarm does not function.
– Alarm time not set.
•See section on Setting alarm time.
– Alarm mode not selected.
•See section on Setting alarm mode.
– Volume too low for radio.
•Increase the volume.
CAUTION
-High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any
-Modification of the product could result in hazardous radiation of EMC or other unsafe operation.