Philips EXP 301, EXP 303 manual Accessories, In-car connections supplied or optionally available

Page 25

Accessories

In-car connections (supplied or optionally available)

Only use the AY 3545 car voltage converter (4.5 V DC, positive pole to the center pin) and the AY 3501 car adapter cassette. Any other product may damage the unit.

English

1Put the unit on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the unit is neither a danger nor an obstacle to the driver and the passengers.

2Connect the DC plug of the voltage converter to 4.5V DC on the unit (only for a 12 V car battery, negative grounding).

4.5 V DC

O

F

F

• R E S U M

E • HOLD

L

3Insert the voltage converter into the cigarette lighter jack. If necessary, clean the cigarette lighter jack to obtain a good electrical contact.

4Turn down the volume and connect the adapter cassette plug to LINE OUT/p on the unit.

5Carefully insert the adapter cassette into the car radio’s cassette compartment.

6Make sure the cord does not hinder your driving.

7Set VOL E on the unit to position 8. Start playback on the unit and adjust the sound with the car radio controls.

Always remove the voltage converter from the cigarette lighter jack when the unit is not in use.

Note: If your car radio has a LINE IN jack, it is better to use it for the

car radio connection instead of the adapter cassette. Connect the signal lead to this LINE IN jack and to LINE OUT/p on the unit.

25

Image 25

Contents Audio SThe exclamation point calls attention to features for Warranty Verification Owner Model Confirmation RegistrationS U M E Hold Line O Hurry Français EnglishRemove batteries when the unit is not used for a long time Battery usage CautionCart, stand, tripod EL 6474-E003 01/6Contents Controls, refer to the illustrations on Hold OFF 5 Play Quick startGeneral information MaintenanceEnvironmental information Do not touch the lens a of the unitHow to organize music ﬁles How to get music ﬁlesMP3 and AAC music ﬁles DEEP.MP3POP, there are no MP3 or AAC ﬁles. POP is therefore skipped How to make a CD-ROM with MP3 or AAC ﬁlesVisit the Expanium homepage Supported formatsAll trademarks used are owned by their respective owners Batteries not supplied Power supplyInserting batteries Power adapter Power supply/HeadphonesHeadphones Connect the supplied headphones to Line OUT/pPlaying a disc Basic functionsPress 2 to start playback Pause Playing Enhanced Music CDs and Mixed Mode CDsInsert the disc and press 2 to start playback Volume adjustment Volume and soundAdjust the volume by using VOL E Sound adjustmentSelecting a track during playback Selecting and searching on all discsSearching for a passage during playback Selecting an album during playback Selecting an album on MP3-CDs onlyProgramming track numbers FeaturesClearing the program All stored tracks are displayed in sequenceLocking all buttons Hold Storing the last position played ResumeSelecting different playback possibilities Mode Acoustic feedback ESP Electronic Skip ProtectionUnit against damage caused by DroppingIn-car connections supplied or optionally available AccessoriesBelt clip Problem Solution TroubleshootingProblem In-car use No sound or bad sound quality In-car useLimited Warranty Exchanging a Product in Canada