TUNER
1Press TUNER/AUX once to switch on the radio (FM only).
™Display shows the radio frequency of the last selected waveband. Your pre- set station is also shown if you are listening to a preset. (See 2)
2Adjust the sound using
3To select preset stations, press the respective PRESET button
TUNING TO RADIO STATIONS
1Press and hold ¡1 / 2™ until the frequency in the display starts changing. ™Display shows “Scrh” during automatic tuning.
™After the system tunes to a station of sufficient reception, display shows its frequency.
• To tune to a weak station, press ¡1 / 2 ™ briefly and repeatedly until an optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to 5 FM radio stations in the memory.
1Tune to your desired station (see TUNING TO RADIO STATIONS).
2To store a preset, hold down briefly on a PRESET button
™ Display shows the preset number of your station.
3Repeat steps 1 and 2 to store your other stations.
• You can overwrite a preset station by storing another frequency in its place.
4Press a PRESET button
™ To display clock time, press 2; on the set.
USING THE ALARM
GENERAL
Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend, and you can set different
•tuner mode.
•buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds.
•dock mode (only for Apple iPod and Philips GoGear SA9100 and SA9200)