Tuner, Tuning to Radio Stations | Philips AJ301DB/79 specs

TUNER

1Press TUNER/AUX once to switch on the radio (FM only).

™Display shows the radio frequency of the last selected waveband. Your pre- set station is also shown if you are listening to a preset. (See 2)

2Adjust the sound using VOL+/-.

3To select preset stations, press the respective PRESET button (1-5).

TUNING TO RADIO STATIONS

1Press and hold ¡1 / 2™ until the frequency in the display starts changing. ™Display shows “Scrh” during automatic tuning.

™After the system tunes to a station of sufficient reception, display shows its frequency.

•To tune to a weak station, press ¡1 / 2™ briefly and repeatedly until an optimal reception is found.

To improve reception (FM):

Extend and position the pigtail fully to obtain optimum reception.

STORING AND USING PRESET STATIONS

You can store up to 5 FM radio stations in the memory.

1Tune to your desired station (see TUNING TO RADIO STATIONS).

2To store a preset, hold down briefly on a PRESET button 1-5 until you hear a dou- ble beep.

™ Display shows the preset number of your station.

3Repeat steps 1 and 2 to store your other stations.

• You can overwrite a preset station by storing another frequency in its place.

4Press a PRESET button 1-5 (or PRESET 4 / 3 on the remote control) to listen to a preset station.

™ To display clock time, press 2; on the set.

USING THE ALARM

GENERAL

Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend, and you can set different wake-up modes:

•tuner mode.

•buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds.

•dock mode