Philips AJ301DB/12 user manual Connecting AN External Device, Maintenance & Safety, Specifications

Page 7

CONNECTING AN EXTERNAL DEVICE

You can listen to the sound of the connected external device through your AJ301DB’s speakers.

1Press TUNER/AUX twice to select AUX mode.

2Use the supplied AUX-IN cable to connect AJ301DB’s AUX IN jack to an AUDIO OUT or headphone jack on an external equipment (such as CD player, or VCR).

MAINTENANCE & SAFETY

Install the unit near the AC outlet and where the AC power plug can be easily reached.

The apparatus shall not be exposed to dripping or splashing.

Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.

To clean your set, use a soft damp cloth or chamois leather. Do not use cleaning products, which contain benzene, thinner, etc. as these may harm the housing.

Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable.

Batteries (battery pack or batteries installed) shall not be exposed to exces- sive heat such as sunshine, fire or the like.

SPECIFICATIONS

 

Power Consumption

24 W

Output power

2 x 6 W RMS

Dimensions (w x h x d)

161 x 191 x 164 (mm)

Weight

1.34 kg

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock!

No sound

Volume not adjusted

• Adjust the volume

The set is muted.

Press”MUTE” on the remote control to active playback sound.

Display error / no reaction to any controls

Electrical malfunction

• Unplug the power cord, then re-plug.

Intermittent crackling sound during FM reception

Weak signal

• Extend and position the pigtail aerial

The alarm does not function

Alarm time/ mode not set

• See SETTING THE ALARM

Volume too low for radio

• Increase the volume

Dock operation

The menu navigation or photo playback of the docked player cannot be

carried out through the buttons on AJ301DB or its remote control.

• The buttons on AJ301DB and its remote control can control playback of audio contents only. To navigate the menu, use the controls on the docked player.

Some buttons on AJ301DB and its remote control have no function.

• The buttons ( 2;, ¡1, 2 ™ and VOLUME) function only.

Image 7
Contents Docking Entertainment System $ % @ ALM Basic Operation Power SupplySELF-POWERED BACK-UP Setting the Clock and DateSetting the Alarm Mode Tuning to Radio StationsStoring and Using Preset Stations Using the Alarm GeneralCanceling the Alarm Completely Switching OFF the AlarmHour Alarm Reset Repeat AlarmTroubleshooting Connecting AN External DeviceMaintenance & Safety SpecificationsDisposal of your old product Enviromental Information