Philips 9500 user manual How to Store a Number for Memory Dialing, Using Memory Dialing

How to Store a Number for Memory Dialing

Each of the four memory dial buttons can store a telephone number that is up to 15 digits long.The telephone numbers stored in memory are automatically dialed with one touch of the appropriate memory dial button.

STEP 1: With the handset on-hook, press the pound key (#).

STEP 2: Enter the telephone number to be stored. Use the star key (*) to insert pauses (if needed).

To access the memory dial card, lift the clear protector up from the rear, and slide the card out of the slot.

STEP 3: Select and press one of the four memory dial buttons within 8 seconds.

•If you successfully complete steps 1–3, your CarePartner Telephone will beep three times and then announce the number you programmed.

•If you fail to complete steps 1–3 properly, your CarePartner Telephone will sound a continuous tone; try again.

STEP 4: Label each key that you program using the card located next to the memory dial buttons.

Using Memory Dialing

To use a memory dial number, lift the handset or press the speakerphone button.Then press the correct memory dial button.To program your memory dial buttons, see the “How to Store a Number for Memory Dialing” section above.

NOTE:

If you make a mistake while programming or wish to change a memory dial number, repeat Steps 1–4.

If you wish to erase a memory dial number, complete Steps 1 and 3 only.

To program a memory dial number properly, you should wait no more than eight (8) seconds between steps.

Your memory dial numbers will not be lost if you lose power or unplug your CarePartner Telephone.

Model 9500 User’s Manual 15