Audiovox VDS102T manual Vehicle Preparation, ~4~

Page 6

VEHICLE PREPARATION:

1)Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good ground generally, these wires can be found at the ignition switch or fuse-box.

2)The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the installation of the video monitor and related console accessories.

3)Generally, the best location for the video monitor is where the vehicle's factory dome light is installed. The monitor should be located in such a manner that it can be comfortably viewed by rear seat passengers.

NEVER INSTALL THE MONITOR IN A PLACE WITHIN THE DRIVER'S VIEW. THIS IS NOT ONLY DANGEROUS, BUT IT IS ALSO ILLEGAL IN MANY STATES.

4)Once the mounting location of the monitor has been determined, there may be additional preparation work necessary, depending on the vehicle structure and installation method. Some of the steps that may be required are:

A)Removal of the vehicle's dome light

B)The headliner may.

C)If the trim ring will be used, it will have to be trimmed to fit the contour of the vehicle's headliner. Refer to the "trim ring installation" section in this manual.

~4~

Image 6
Contents VDS102T DROP-DOWN Video Montor Important Notice Materials Included in this Package Tools Required~1~ Three position Dome Light Switch ~2~General Installation Approach System Options~3~ Vehicle Preparation ~4~Trim Ring Installation ~5~Mounting the Trim Ring VDS102 ~6~~7~ Connecting the Dome Lights ~8~Negative Switched Dome Lighting ~9~
Related manuals
Manual 16 pages 50 Kb