Cambridge Audio iD50 user manual Technical specifications, Operating instructions, Inputs/Outputs

Page 10

Operating instructions (continued)

Shuffle Mode

Selecting this item allows you to choose any of the following:

Shuffle Tracks (standard shuffle mode – plays songs in the current selection in a random order);

Shuffle Albums (after the current album playing has finished, a random album will be selected and playback will resume); Shuffle Off (your music selection will play in order).

Repeat Mode

Repeat Tracks (plays each song in the current selection, then starts again);

Repeat One Track (repeatedly plays the selected song); Repeat Off (no songs are repeated).

Charging

The iD50 docking station also charges the iPod battery while it is in the dock. However, the iPod’s battery charging circuit can introduce a little noise to the audio and video outputs. By switching the charging off, the listener is provided with the best possible listening experience.

Note: if the battery is completely flat, the iPod may not respond for a short while.

For more information on battery recharging, please consult your iPod manual.

Video Auto Fit

When this option is selected, the iPod attempts to enlarge the video image to fill the screen so that the top and bottom or left and right edges end at the screen edge without losing any vertical or horizontal image information.

Depending on the iPod media and aspect ratio of the screen as selected below, this may still result in adding either letterbox black bars at the top and bottom of the screen or pillarbox black bars at the left and right of the screen.

Widescreen Mode

Use this mode when your video monitor/TV has a horizontal- to-vertical aspect ratio of 16:9 (widescreen) rather than 4:3 (normal). This setting tells the iPod that your TV is widescreen so that it can make the best choice of video mode. Depending on the media source format and this screen configuration preference, the media content may be displayed in full widescreen fitting the screen, or have pillarbox bars as described above.

Language Settings

Use to select between various different languages for the iD50’s On-Screen Display.

Technical specifications

THD

< 0.005% @ 1kHz

S/N

< -75dB @ 1kHz

Output level

1.7-2.0V rms nominal

Standby power

<1.3W idle

consumption

 

Maximum power

2.5W in operation and charging

consumption

at maximum rate

Inputs/Outputs

Power adaptor input

100-240V ~ 50/60Hz

Power adaptor output

7.5V DC, 500 mA

Composite video output

x 1

S-Video out

x 1

RS232

x 1

 

Tip: TX from dock, Ring: RX to

 

dock, Screen: Ground

 

9600 BAUD, No check bit,

 

1 Stop Bit, No RTS/CTS or

 

XON/XOFF required

 

See website for command

 

protocol.

Remote control

Battery

Coin Cell type: V3, CR2032 or

 

equivalent

10

Image 10
Contents ID50 ContentsIntroduction Important safety instructions ID50Limited warranty VentilationRear panel Connections Dock connectorFront panel Remote sensorRemote control Operating instructions Configuring your iD50Navigation Music Menu Settings MenuMenus Videos MenuOperating instructions Technical specificationsRemote control Inputs/OutputsRemote control does not function TroubleshootingDocking station does not charge the iPod’s battery There is no video on the TVAP21793/2