Cygnett i-x6 manual Installation6, Connecting the dock and i-X6 Speakers

Page 9

Installation6

Connecting to your iPod

Insert appropriate

iPod connector

 

iPod adaptor for

Dock your iPod here

your iPod here

 

 

Remote Control receiver

1. USB

2. DC In

3. Audio Connection

4. S-Video

Connecting the dock and i-X6 Speakers

1.Connect the dock to the speakers using the included 5 metre Audio

(3) and DC (2) cable to connect the audio and provide power

to charge your iPod.

2.For viewing video footage, connect the S-video cable to the dock (4) and into your television. This requires an iPod with video capabilities. Make sure video output is set to on & settings on your iPod are correct. ie. PAL or NTSC.

3.To sync your iPod with your computer, connect the included USB cable from the dock (1) to your computer. Your iTunes should automatically start after a short while and sync with your iPod.

4.Once you have connected the cables to the rear of the dock, slot in the appropriate insert for your iPod. Then dock your iPod on the iPod connector

To take full advantage of the stereo sound, we recommend you place the dock close to the centre of your entertainment system and separate the speakers.

5.To adjust the volume via the dock press the (+) or (-) buttons on the front of the dock or on the remote.

Image 9
Contents Page Warranty Safety Precautions Contents1 Welcome Introduction2Whats in the Box? Two i-X6 speakers Left and RightX6 Features Features3Front Panel Features Rear Panel FeaturesFeatures4 Installation5 PrecautionsConnecting the Speakers Connecting the dock and i-X6 Speakers Installation6Operating the Speaker System via remote control Remote Control FeaturesOperation7 Specifications8 Mail info@cygnett-unison.com For help or technical support