Functions of Controls, Indicators and Connectors (Cont)
1.POWER ON/OFF Rocker Switch: When pressed to the ON ( I ) position, AC input power is applied to the radio system, placing it in the standby mode.
2.AC IN Power Connector:
3.SUB OUT Audio Connector: Female RCA audio output connector to external subwoofer speaker.
4.L / R AUX 2 INPUT Connectors: Female RCA audio input connectors for connection to external audio equipment such as a CD player or other audio output source.
5.
6.AM ANTENNA / 300 OHM Terminals: Provide connection for the AM loop antenna for AM signal reception.
7.FM ANTENNA / 75 OHM Connector: Provides connection for the FM antenna F connector for FM signal reception.
8.Protective Cover: Covers the iPod connector bay when iPod is not in use.
9.VOLUME Control: Continuous rotary control wheel for increasing and decreasing the volume of the audio output level; clockwise (CW) rotation increases volume, counterclockwise (CCW) rotation decreases volume.
10.POWER (
) Pushbutton : Momentarily pressing this button applies power to the radio system, switching from the standby to on mode and
11.AUX 2 Indicator: This LED indicator lights blue when the AUX 2 mode is selected using the MODE switch.
12.AUX 1 Indicator: This LED indicator lights blue when the AUX 1 mode is selected using the MODE switch.
13.iPod Indicator: This LED indicator lights blue when the iPod mode is selected using the MODE switch.
14.FM Indicator: This LED indicator lights blue when the FM mode is selected using the MODE switch.
15.Ventilation Port: Provides cooling air for the audio power output vacuum tubes.
16.AM Indicator: This LED indicator lights blue when the AM mode is selected using the MODE switch.
17.MODE Pushbutton: Each time this button is pressed, the radio system operating mode switches in sequence from AM through AUX 2 and back again.
18.iPod Connector Bay: Provides male
19.TUNE Indicator: Intensity of this amber LED is proportional to station tuning accuracy; the brighter the LED, the more optimum the reception.
20.Tuning Dial: This vernier control provides selective tuning of the AM and FM stations; the upper dial indicates the FM frequency range from 87.5MHz to 108MHz, while the bottom dial indicates the AM fre-
quency range from 530kHz to 1710kHz.
21.Audio Power Tube Windows: These windows provide a means of observing the left and right channel power output vacuum tubes.
22.Audio Headphone ( 
) Jack: Provides a 3.5mm connection for audio headphones.
23.Infrared (IR) Window: IR receiver for commands from the remote control.
24.AUX 1 Input Jack: Provides a 3.5mm stereo input connection for an MP3 player or similar device.
25.STEREO Indicator: This green LED illuminates when the FM station is broadcasting in stereo mode.
*Refer to iPod compatibility list on page 9.
8 | AV100 |