Polk Audio 40-1493 manual Remote Control

2.Dock Your iPod. With your miDock™10 turned off, slide the Slide Connector to the left for iPod nano or to the standard position (right) for all other models.

Flip the flat-plate adapter to accommodate changes in depth between the Video iPods and the other iPods that share slots in the docking cradle.

Slide the supplied adapter that matches your iPod into your miDock™10 docking cradle.

For best sound performance, turn off the iPod EQ settings. Follow the instructions for EQ settings that were supplied with your iPod.

Insert your iPod into the docking cradle and push down gently but firmly to ensure that the docking connector is fully seated and your iPod is securely held in the cradle.

Caution—Listen To This!

Slots for your miDock™10 adapters are clearly marked inside the docking cradle. Use the slot that matches your iPod to ensure a proper fit for your iPod and to prevent connector damage.

Press to Open the Docking Cradle

				Slide
				Connector
3. Turn It Up! Your miDock™10 turns on automatically when you insert	Caution—Listen To This!
your iPod. To play music, press play on your iPod or remote control.	Set your miDock™10 volume at a safe level before playing music.
		Power
		Volume
		Track Skip (Hold for
		Fast-Forward or Rewind)
Remote Control
Before using the remote control for the first time, pull out the plastic
tab from the battery compartment.
To replace the remote control battery (CR2025), carefully insert a thin			Power
object into the battery release, slide the tab over and hold it. Then			Play/Pause
slide the battery compartment open.
Battery			Volume
Release

•Use only fresh battery of the required size and

	recommended type.	Track Skip
•	Dispose of old battery promptly and properly.
		(Hold for Fast-Forward
	Do not burn or bury it.
		or Rewind)
•	If you do not plan to use the miDock™10 for a
	month or longer, remove the battery. Battery
	can leak chemicals that can damage electronic
	parts.