LISTENING TO THE FM RADIO
1.Press the 
(Standby/On) button to turn the unit on.
2. | Press the TIME/Fn button to tuner mode. | ||||
3. | Press the |
| or |
| button to tune in to a station. |
|
| ||||
|
| ||||
• Adjust the VOLUME control to obtain the desired volume.
Searching for a Station Automatically
•Press and hold the 
or 
button until the tuner starts searching for a station, then release. After finding a clear station, the search stops automatically.
Note: The search may not stop at a station with a very weak signal.
Presetting Stations
The unit can store a total of 20 stations in memory. Presetting allows you to tune in to a station directly.
1.Tune in to a desired station (see previous section).
2.Press the MEM button. The preset number will blink and the “MEM” indicator will be shown on the display.
3.Press the PRESET button repeatedly to select the preset number you desire.
4.Press the MEM button again to store it in memory.
5.Repeat steps
Tuning in to a Preset Station
Press the PRESET button repeatedly to select a preset station that you would like to enjoy.
For Better reception
Fully unwind the antenna wire. Extend the antenna wire and place it in the position that sounds best.
Notes:
•When the reception is good, the “STEREO” indicator will appear on the display.
•Do not connect the FM antenna to an outside antenna.
LISTENING TO YOUR iPod/iPhone
LISTENING TO YOUR iPod/iPhone
Start Playback
1.Press the 
(Standby/On) button to turn on the unit.
2.Press the TIME/Fn button repeatedly until the “ 
” indicator appears on the display.
3.Then the iPod/iPhone will start playing automatically.
Notes:
•The iPod/iPhone will be charged automatically (until fully charged) whilst it is docked in the cradle (Except when you are listening to the radio.).
•If your iPhone is called while it is docked, playback will be paused.
Pausing Playback
•Press the 
button.
•To resume playback, press the 
button again.
Skipping to a Another Track
•Press either the 
or 
button according to the desired direction.
•Press the 
button to skip to the beginning of the current track or previous track. Press the 
button to skip to the beginning of the next track.
Locating a Particular Point on a Track
•Keep either the 
or 
button pressed during playback, according to the desired direction, and release at the desired point.
Note: Please refer to the owner’s manual that was supplied with your iPod/iPhone for more details.
DUAL ALARM SETTING
•The unit should be in STANDBY mode to set alarm.
•The alarm can be set to activate twice a day by setting two different alarm times in ALARM1 and ALARM2.
•The unit can be set to “BUZZER”, “TUNER” or “ 
” alarm.
To Set Alarm 1 | Hour Digits Minute Digits |
|
1. Press the ALM 1 button, then the “ ” icon, hour & minute digits blink |
troubleshooting guide
Problems | Solutions | |
Clock |
|
|
Clock does not show the correct time. | • | There has been an electrical power interruption. Reset the clock. |
Alarm does not come on at the preset • | Is the current time correctly set on the time display? | |
time. | • | Is the alarm time correctly set? |
RADIO |
|
|
Poor FM reception | • | Make sure FM antenna wire is fully extended. |
| • | Electrical interference in your home can cause poor reception. Move the |
|
| unit away from them (especially those with motors and transformers). |
iPod/iPhone |
|
|
iPod/iPhone does not dock properly or does • | Remove your iPod/iPhone from the dock and check for obstruction on | |
not install properly. |
| the connectors in the dock and on your iPod/iPhone. Make sure you are |
|
| using the appropriate adapter for your model of iPod/iPhone. |
iPod/iPhone does not respond to the • | Make sure that your iPod/iPhone is working properly before docking into | |
speaker system. |
| the unit. Please refer to your iPod/iPhone manual for details. |
SPECIFICATIONS
AC: 120V ~ 60Hz AC SUPPLY
BACKUP BATTERIES FOR CLOCK: 2 x “AA SIZE”
RADIO FREQUENCY: FM 87.5 ~ 107.9MHz
LIMITED WARRANTY
VENTURER ELECTRONICS (“VENTURER”) makes the following limited warranty. This limited warranty extend to the original consumer purchaser and is limited to
Ninety (90) Day Parts & Labor Warranty
VENTURER products purchased in the United States or Canada are warranted to be free from defects in materials or workmanship for a period of ninety (90) days from the date of their original retail purchase. If the unit fails to conform to this warranty, we will service the product using new or refurbished parts and products, at VENTURER’s sole discretion.
Compatible iPod/iPhone Types
•iPod nano (1st generation)
•iPod nano (2nd generation)
•iPod nano (3rd generation)
•iPod nano (4th generation)
•iPod nano (5th generation)
•iPod classic
Installing an iPod/iPhone Dock Adapter
•iPod touch (1st generation)
•iPod touch (2nd generation)
•iPhone
•iPhone 3G
•iPhone 3GS
Removing an iPod/iPhone Dock Adapter
| on the display. |
2. | Press the HOUR button to adjust the hours. |
3. | Press the MIN button to adjust the minutes. |
4. | Press the TIME/Fn button to select “BUZZER”, “TUNER”, “ ”. |
Note: The shown “TUNER” icon represents Radio (FM) mode. | |
5. | Adjust the volume control to obtain the desired volume for the Alarm1. |
6. | Press the ALM 1 button again to confirm. |
7. | The alarm 1 indicator will light up. |
Notes:
Alarm 1
Indicator
AM
Alarm 2
Indicator
During a period of ninety (90) days from the effective warranty date, VENTURER will provide, when needed, service labor to repair a manufacturing defect at its designated Service Center. To obtain warranty service in the United States or Canada, you must first call our Customer Support Center at (800)
1.Before connecting your iPod/iPhone, we recommend you install the appropriate iPod/iPhone Dock Adapter
(supplied with the iPod/iPhone or sold separately) in the dock of the unit.
2.Insert your iPod/iPhone Dock Adapter (not included) into the dock until it sits firmly in place.
iPod/iPhone Dock Adapter (not included)
Remove the Dock Adapter by gripping the inside with your thumb, then lifting out the adapter using the friction between your thumb and the adapter.
•For the “TUNER” Alarm, you should tune into your desired station in FM band before setting alarms, and it will turn on to the last station you tuned in.
•For “ 
” Alarm, insert your iPod/iPhone into the connector. If no iPod/iPhone is inserted, it will alarm to the buzzer instead.
The clock radio will wake up to “BUZZER”, “TUNER”, “ 
”, when alarm timer reaches the preset time and then turns off automatically after 60 minutes.
Note: After the unit wakes up to “TUNER” or “ 
”, you can adjust the volume control to obtain the desired volume.
To Set Alarm 2
Setting the alarm for alarm 2 is the same as setting alarm 1 (Use the ALM 2 button instead of the ALM 1 button). Note: If the Alarm 1 & Alarm 2 are set to the same time, the unit will alarm once only.
To Turn Off Alarm
1.Snooze (If you want to snooze a few more minutes)
Pressing the SNOOZE button will deactivate the sound for 9 minutes. Snooze function continues to operate 1 hour after the preset alarm time.
2.To stop alarm sound
Press the 
(Standby/On) button to stop alarm sound, and it will resume after 24 hours.
To Change the Alarm Time
Set the alarm time again.
To Cancel Alarm Mode
Packaging and Shipping Instruction
When you send the product to the VENTURER service facility you must use the original carton box and packing material or an equivalent as designated by VENTURER.
Your Responsibility
(1)You must retain the original sale receipt to provide proof of purchase.
(2)These warranties are effective only if the product is purchased and operated in the United States or Canada.
(3)Warranties extend only to defects in material or workmanship, and do not extend to any product or parts which have been lost or discarded, or damage to product or parts caused by misuse, accident, improper operation or maintenance, or use in violation of instructions provided with the product, or to product which has been altered or modified without authorization of VENTURER, or to products or parts thereof which have had the serial number removed or changed.
Out of Warranty
In the event your product requires repair after the limited warranty period has expired, please contact our Customer Support Center at
Hours:
Important:
You are responsible for any transportation, shipping or insurance relative to the return of product to our Product Returns Center.
All warranties implied by state law, including the implied warranties of merchantability and fitness for a particular purpose, are expressly limited to the duration of the limited warranties set forth above.With the exception of any warranties implied by state law as hereby limited, the foregoing warranty is exclusive and in lieu of all other warranties, guarantees, agreements
Inserting Your iPod/iPhone
1.Ensure an appropriate iPod/iPhone Docking Adapter is installed.
2.Insert your iPod/iPhone into the connector in the dock.
- 4 -
Press and hold the ALM 1 or ALM 2 buttons for 2 seconds until the alarm1 or alarm2 indicator disappears. Note: Press and hold the ALM 1 or ALM 2 buttons for 2 seconds again to resume the previous alarm mode.
sleep timer setting
The sleep timer turns the unit off automatically at a
1.While the unit is on, press the SLEEP button, “
” will blink and “90” will be shown on the display.
2.Press the SLEEP button repeatedly to select the desired sleep time (in minutes) as listed below:
OFF 
Note: “OFF” means the sleep mode is disabled.
3.After setting a desired sleep time, the “
” icon will be shown on the display.
4.The unit will automatically turn off once it reaches the sleep time.
• To clear the preset sleep time, press the SLEEP button repeatedly until “OFF” appears.
MAINTENANCE
Cleaning the Unit
•Be sure to turn off the unit, disconnect the power adapter and remove all external connections before cleaning the unit.
•Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has been dipped in a weak
•Never use alcohol, benzene, thinner, cleaning fluid or other chemicals. DO NOT use compressed air to remove dust.
-5 -
and similar obligations of manufacturer or seller with respect to the repair or replacement of any parts. In no event shall VENTURER be liable for consequential or incidental damages.
No person, agent, distributor, dealer or company is authorized to change, modify or extend the terms of these warranties in any manner whatsoever. The time within action must be commenced to enforce any obligation of VENTURER arising under the warranty or under any statute, or law of the United States or Canada or any state thereof, is hereby limited to ninety (90) days from the date of purchase. This limitation does not apply to implied warranties arising under state law.
This warranty gives you specific legal rights and you may also have other rights, which may vary, from state to state. Some states do not allow limitation on how long an implied warranty lasts, when an action may be brought, or the exclusion or limitation of incidental or consequential damages, so the above provisions may not apply to you.
For more information on other products and services, please visit our web site at
www.1800customersupport.com
Important: Also keep your “Bill of Sale” as proof of purchase.
Model no | Product name |
Type of set | |
Serial no | Invoice no |
Date purchased | Dealer name |
FOR SERVICE AND REPAIR, PLEASE VISIT www. 1800customersupport.com
Design and specifications are subject to change without notice.
As concerns grow about the environmental impact of outdated electronic products, Venturer Electronics is committed to being a part of the solution. Free of charge, Venturer Electronics customers can return qualifying units to us for recycling. For more details, please visit our website at www.venturer.com/recycle or call
Printed in China |