Installation During NEW Construction, Warranty

INSTALLATION DURING NEW CONSTRUCTION

Needless to say, installing In-Wall speakers when a house is being built is far easier than doing it later.

Russound offers a ‘Speaker Rough-In Kit”. The SB-3.6 Rough-In kit is designed to provide the drywall installers the cut-out for the In-Walls. The kit comes with two brackets, one for the left speaker and another for the right. The brackets are nailed/screwed onto the wall studs.

Once the house/room is completed, you can install the speaker (more on this below).

During new installation, keep the following tips in mind:

•Use a small level to verify that the mounting frame is straight.

•The flat brackets and nails which attach the speakers are thin enough that they won’t interfere with wallboard added later.

•If possible, run speaker wires after AC wiring is in place to avoid induced hum caused by close parallel proximity.

•Secure speaker wires in place along the run with insulated staples only and be careful not to pierce the insulation. Allow a bit of slack for expansion of building materials.

•The actual speakers should not be installed until the wall board is in place. In the meantime, leave several feet of wire coiled up and secured to the back side of the mounting frame.

•When it comes time to put up the dry wall, make sure the speaker cut-out hole doesn’t extend farther than 1/4” from the sides of the mounting frame.

•After the wallboard is put up, install the speakers as detailed on pages 5 of this manual.

Due to our continual efforts to improve product quality as new tech- nology and techniques become available, Russound/FMP, Inc. reserves the right to revise speaker systems specifications without notice.

WARRANTY

All Russound Speaker products are fully guaranteed against all defects in materials and workmanship for five years from date of purchase. Proof of Receipt must accompany all claims. During the warranty period Russound will replace any defective part and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If necessary, repairs must be performed by Russound. The unit must be returned to Russound at the owner’s expense and with prior written permission. Accidental damage and shipping damage are not considered defects, nor is damage resulting from abuse or from servicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to application of excessive power voids the warranty on those parts. In these cases repairs will be made on the basis of the retail value of the parts and labor. To return for repairs, the unit must be shipped to Russound at the owner’s expense, along with a note explaining the nature of service required. Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit.

This Warranty Does Not Cover:

•Damage caused by abuse, accident, misuse, negligence, or improp- er operation (installation).

•Products that have been altered or modified.

•Any product whose identifying number or decal, serial #, etc. has been altered, defaced or removed.

•Normal wear and maintenance.