JVC HR-XVC1U manual Stereo Recording and Playback, Separate Audio Program SAP, Output selection

Stereo Recording and Playback / Separate Audio Program (SAP)

Stereo Recording and Playback

The VHS Hi-Fi audio system permits high fidelity recording of MTS STEREO TV broadcasts.

TV VCR DVD POWER

DVD MENU	MARKER	RETURN	OPEN/
			CLOSE
DISPLAY	A.TRK	C.RESET	ZERO RETURN
	SUB TITLE	ANGLE	SEARCH
			MODE
SP/EP
PLAY	ZOOM	TITLE	REPEAT
MODE			A-B

							TV
							POWER
							INPUT
							TV VOL
0	TIMER				TV/VCR
REW				PLAY			FF
REC				STOP			PAUSE
			/VCR		CH
SKIP		TV				+	SKIP
/INDEX							/INDEX
SET			ENTER/				SET
			SELECT
SET UP							CANCEL
MENU
		T				—
					H
			V/VCR C
OSD					SLOW		SKIP
	A.	MONITOR					SEARCH

VCR/DVD/TV

NOTES:

•When playing back a tape that is not recorded in Hi-Fi stereo mode, the audio will automatically be monaural.

•When listening to a VHS Hi-Fi video tape or MTS broadcast through the VHF/UHF jack (Audio/Video cord not connected), the sound will be monaural.

When a MTS STEREO broadcast is received, the word STEREO will appear

on the screen and the program can be STEREO viewed or recorded in stereo.

The Hi-Fi STEREO recording procedure is the same as for normal recordings.

NOTES:

When using a CATV system, stereo TV programs may be transmitted over a mono cable channel. In this case the word "STEREO" will not appear and the sound will be in mono.

Output selection

When viewing an MTS STEREO TV program, or playing a prerecorded VHS Hi-Fi STEREO videotape, press A. MONITOR to select how the audio will be heard through the speakers. Normally set to the Hi-Fi STEREO position, this button can be set to the MONO position if the stereo broadcast or videotape audio is of poor quality. The "R" and "L" positions allow the audio from the Right or Left Hi-Fi channel to be heard over both TV speakers. This button has no effect when viewing a MONO videotape or TV program. Each time when you press the button, OUTPUT SELECTION display appears on the screen for several seconds. Refer to the chart below.

OUTPUT	SOUND HEARD ON BOTH
SELECTION	SPEAKERS
STEREO	STEREO
L ch	LEFT CHANNEL AUDIO
R ch	RIGHT CHANNEL AUDIO
MONO	MONO

Separate Audio Program (SAP)

Your VCR is fitted with a SAP broadcast system which enables you to switch to a separate audio program when viewing a selected channel.

This function applies only when the program is broadcast in multi-languages through the SAP broadcast system.

1 Press SETUP MENU. Then press		or to select SAP.
2	Then press ENTER to select [ON].		MENU
			TIMER REC SET	ON	OFF
	Then press SETUP MENU until		AUTO REPEAT
			SAP	ON	OFF
	the menu screen is cleared.		CH SET UP
			SYSTEM SET UP

·+/-/ENTER/MENUÒ

Listening to SAP

When the VCR is turned on or a channel selection is made, make certain the letters "SAP" appears on the screen. This means that the "Separate Audio Program" broadcasting is available.

STEREO SAP SAP

OR

33