GB
Where to Install Your
Micro Component System
To take full advantage of your new micro component sys- tem,
follow these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
For ventilation purposes,maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system.
Make sure that you have enough room to open the com- pact disc compartment easily.
Connecting your System to the Power Supply
Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the micro component system
Find that the remote control is no longer operating cor- rectly
When replacing the batteries, use a new set of batter- ies and never mix alkaline and manganese batteries.
1Place your thumb on the position marked 
on the battery compartment cover (rear of the remote con- trol) and pull the cover in the direction of the arrow.
2Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
3Replace the cover by sliding it back until it clicks into position.
Connecting to an External Source
The auxiliary input can be used to take advantage of the sound quality of your micro component system when listening to other sources.
Examples: 
A television
A DVD player
A VCR
To connect to the external source, the source must have an audio output.
1Set the system to standby mode and disconnect it and the external source from the AC outlet.
2Connect the audio cable to the rear of the micro com- ponent system.
For optimum sound quality, do not invert the right and left channels.
3Plug the system back into the AC outlet and press
( 
) to switch it on.
4Select the AUX source by pressing FUNCTION. Result: AUX is displayed.
5Switch the external source on.
Example: You can watch a film on your DVD Player and take advantage of stereo sound this unit provides.
iPod Connection
GB
You can listen to the audio from an iPod through the main unit.
1Set the system to standby mode and disconnect it and the external source from the AC outlet.
2Choose the appropriate iPod adapter and place into the micro component system.Place the iPod into the adapter and connect the iPod player to the top of the micro component system.
3Plug the system back into the AC outlet and press
( 
) to switch it on.
4Select the iPod source by pressing FUNCTION. Result: Apple is displayed.
5Switch the iPod on.
The power cord must be plugged into an 120V AC wall outlet.
1Plug the power cord into an AC outlet.
2Press the ( 
) button to switch your micro compo- nent system on.
Audio Cable |
If the external analog |
component has only |
one Audio Out, connect |
either left or right. |
When the unit is powered on and you connect an iPod MP3 player, the unit will charge your iPod's battery.
iPod is registered trade mark of Apple Computer,Inc.
6 | 7 |