Connecting yepp to PC with USB cable
3 Plug one end of the USB cable into the USB port on the back of the PC.
● The yepp will automatically turn on.
4 Connect the opposite end of the USB cable to the USB cable port on the bottom of the yepp.
●If you disconnect the USB cable from your PC while implementing a command or initializing during USB driver installation, your PC may not function correctly.
5 USB driver is installed with a message saying that it is searching for a new device. You may not see the display screen during installation.
Go to the device manager to check that installation has been successfully completed.
6 Upon installation of the USB driver "SAMSUNG
[System Properties] ➝ [Device Manager].
USB connect cable
Note :
HowHow toto checkcheck USBUSB driverdriver
Windows 98:
Control Panel ➝ System ➝ Device Manager ➝
Universal Serial Bus controllers/SCSI and RAID controllers
Windows 2000:
Control Panel ➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device
Windows XP:
Control Panel ➝ System ➝ Hardware ➝
Device Manager ➝ Universal Serial Bus controllers ➝
USB Mass Storage Device
Note :
If the
7 When USB driver is not Installed automatically, refer to next page.
Note :
For WinXP, the following window will appear whenever you connect the USB cable to your
14 | 15 |