T6 CAN ENG0.0 1/18/05 13:1412:0 Page 30
MP3 Encoding
✽To move to other modes from the LINE_ENC mode, refer to page 37 "Changing Mode"
1 Connect the Audio Output port on the external audio source
(or the Line Out port) to the ENC port on the device with the Line cable.
2 Press and hold the REC button to start MP3 encoding.
●If the 
button is pressed, encoding is paused and if the 
button is pressed again, the encoding resumes.
3 If the REC button is pressed during encoding, the encoding stops and an encoding file is created.
● The files are encoded in the order of L001, L002....
and saved as MP3 file in LINE_ENC folder after encoding.
✍ Note
- Bit Rates can be set within the range of 32Kbps~128Kbps. (see page 50). - Volume can be adjusted while monitoring the Encoding.
✍ Notice
- Do not disconnect the Line cable during Encoding.
- If the battery is not sufficiently charged, the player will not completely encode the file. - Adjust the volume of the external audio source to a suitable level and encode it.
Searching for Music/Voice Files
To search for specific parts during play
●Push and hold the joystick left or right during playback to search for the part you want to listen to.
●Release the joystick to resume play normally.
To change tracks during play
●Push the joystick to the 
position briefly during playback to play the next track.
●Push the joystick to the 
position briefly within 5 seconds after playback starts,
to move to and play the previous track. Press the joystick to the 
position briefly after five seconds to play the current track from the beginning.
To change tracks when stopped/paused
●Push the joystick left or right in stop/pause mode to move to the previous/next track.
✍Note
-VBR(Variable Bit Rate) file: A file that constantly changes the compression rate according to the type of sounds, such as their pitch, in the file.
-When playing a VBR file, you cannot move to and play the previous track even if you push
the joystick to the 
position within 5 seconds after playback starts.
-Files that were downloaded in MP2 or MP1 and had their file extension changed to MP3 may not play.
30
If the volume level is too high, the sound quality may be poor.
31