Searching for Music/Voice Files

To search for specific parts during play

●A desired passage can be searched for by pressing and holding down the

, buttons during play.

●If the button is pressed during play, the next track is played.

●If the button is pressed before five seconds have passed since starting to play a track,

the previous track is played and if the button is pressed after five seconds, the current track is replayed from the beginning.

●If the , buttons are pressed when stopped, the yepp moves to the previous or next track, respectively.

Note

●VBR(Variable Bit Rate) file: A file that constantly changes the compression rate according to the type of sounds, such as their pitch, in the file.

●With VBR files, pressing the button within 5 seconds from the start of the track may not result in the previous track playing.

●Files that were downloaded in MP2 or MP1 and had their file extension changed to MP3 may not play.

Encoding MP3s

1 Connect the Audio Output port on the external audio source

(or the Line Out port) to the ENC port on the device with the Line in cable.

2	If the ENC button is pressed, MP3 encoding begins.
	● If the	button is pressed, encoding is paused and if the	button is pressed again,

3	the encoding resumes.
	If the ENC button is pressed during encoding, the encoding stops and an
	encoding file is created.

●Encoding is performed in order (ENC001, ENC002, etc.) and files are saved in the MP3 format after encoding.

Note

●The bit rate can be set to 64Kbps, 96Kbps and 128Kbps.

●During encoding, there is no beeping sound and the button lights and backlight do not illuminate.

Caution

●Do not disconnect the Line cable during Encoding.

●If the battery is not sufficiently charged, encoding will not be done.

●Adjust the volume of the external audio source to a suitable level and encode it.

If the volume level is extremely high, the sound quality may not be good.	43