Operation

Battery

Charge the battery for at least 10 hours before using the PA916 or PA916-PS. Simply plug the power cord into an AC outlet and charging begins automatically. The charging indicator will ash until fully charged, then it will stay green. The unit can be used while it is plugged in for charging.

There are two indicators above the main power switch. When the unit is turned on, the one on the left will light ÒredÓ when the battery has a low charge. The one on the right will glow ÒgreenÓ if the battery is fully charged or if operating on A/C power.

It is recommended that the battery be recharged after several hours of usage, rather than stored with a low battery. This will prolong battery life. Storing more than 30 days without recharging will deteriorate the battery.

Digital Master Volume Control

When the main power switch is turned on, the Digital Master Volume Control is at the lowest level to prevent accidental damage to the amplier or internal speakers. The volume can be controlled in two ways; using the ÒUpÓ ÒDownÓ buttons on the mixer panel or using the RC-300 infrared remote control. The remote sensor must be used in front of the speaker as the sensor is behind the speaker grille.

Recommended Set-up Procedure

Ideally the master volume should be at maximum volume before the wireless receiver and microphone volumes are adjusted to the desired loudness. Since there are always at least two (2) volume controls to contend with, it is suggested that prior to turning the power on the UHF receiver volume controls be set at Ò10 oÕclockÓ. Also set the microphone volume controls at Ò10 oÕclockÓ. Turn on the main power switch and use either a wireless microphone or cabled microphone to adjust the master volume.

Tape & CD

The main power switch does not control the CD and Tape recorder. A separate power switch is combined with the Tape/CD volume control to limit battery drain when the Tape or CD are not being used.

Wireless Receivers

There are two (2) independent combination XLR/1/4Ó jacks for using microphones with cables. Each jack has a volume control which eects the loudness of both wired and wireless microphones. Also each has a ÒVoice/MusicÓ switch. On ÒmusicÓ program the sound is full delity, while on ÒvoiceÓ the sound is tailored to give maximum projection while limit - ing battery drain.