Bose EN50081-1, EN50082-1, BOSE251BLK, BOSE251WHT manual Attaching the speakers to the brackets

Installing Your 251TM Speakers

Installing the mounting brackets (cont.)

Installing the brackets onto a deck railing or table (cont.)

Finally, install the four screws using a Phillips-head screwdriver (Figure 10).

Figure 10

Installing the bracket onto a deck railing or table

Note: If you are mounting your 251TM speakers on a deck railing or table, you will need to rotate the Bose logo. Refer to ÒRotating the Bose logoÓ on page 11 for instructions on how to do this.

Attaching the speakers to the brackets

Once the brackets are installed, carefully follow these steps to attach the speakers to the brackets. First, insert the knobs into each side of the speakers. Be sure to turn each knob two full rotations (Figure 11). Then, carefully slide the speakers into the brackets (Figure 12). Finally, temporarily tighten the speaker in a position that will allow you to easily connect the speaker wire (Figures 13A and 13B).

Figure 11

Installing the knobs

two full rotations

Figure 12

Sliding the speakers into the brackets

8