Haier FCD-JTHC80A-III (E), FCD-JTHC100A-III (E) Setting Environment, Causing scalding and leakage

Page 6

Setting Environment

Do not locate in freezing places. If

 

ice forms, tank and pipes will break,

Do not install it outdoors.

causing scalding and leakage.

 

Do not install it as stand-alone.

It shall be hung on firm and solid wall.

Do not install it in places unable to drain

If a drain hose is connected, it shall be

water.

connected to sewage drain, avoiding

 

spilling the room.

The tubes and pipes fitted on the product are inseparable parts of the Safe Care technology, and shall not be removed by yourself. Otherwise, Haier shall not be liable for any damages or injuries caused due to resulted potential risks.

Symbol Denotation

Do not proceed!Wrong operation may cause fatal injury or death.

Do follow the instructions!Wrong operation may cause human injury or house property loss.

Installation

Installation must be made by installers of or designated by our company after-service department.

The water heater shall be wall-mounted.

Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deepin the wall. Insert and fix expansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert wall rack onto the hooks and bolts. Fit flat washers, rear wires, spring washers and nuts in turn onto the bolts. Tighten the nuts and check them firm. Install accessories such as safety valve, drain hose as shown in Fig. 2. Use sealing compound to prevent water leakage.

To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at appropriate locations on inlet and outlet pipes respectively. Find water supply location. Connect inlet pipe, outlet pipe and city water pipe respectively to the use point.

Note: To avoid heat dissipation, hot water pipe shall not be too long.

For easy future maintenance and repair, adequate space must be reserved during installation.

Fig.2 For Installation Information Only

 

 

 

Hot

 

 

 

water

 

 

 

outlet

 

 

 

Safety valve

 

 

 

Cold water inlet

Hot water

Cold water

Showerhead

valve

 

valve

Mixing valve

 

 

 

(Fig.3)

Image 6
Contents Little Sea-ox Pre-safe expert Friendly HintsBefore Usage Cleaning and MaintenanceFeatures Packing ListDimensions Operation Instructions Electric Circuit DiagramModel Installation Safety PrecautionsSetting Environment Causing scalding and leakage