Alesis MONITORONEMK2 manual Installation

Page 19

chapter 2 • installation

To connect wires to the terminals if you are not using a banana plug:

1.Strip about 1/2" (15 mm) of insulation from the ends of each wire. If the wire is stranded, twist the strands together at the end.

2.Turn the red and black terminal caps counter-clockwise until they reach their limit. As you do, the hole through the terminal post will be exposed.

3.Insert the wires into the holes, observing proper polarity.

4.Tighten the terminal caps so that they hold the wire firmly.

Make sure no insulation is caught inside the terminal, to avoid a loose connection.

Monitor One Mk2 Reference Manual

15

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Page Page Owners Reference Manual Alesis Contact Information Thank you Table of ContentsPlease follow these precautions when using this product Safety symbols used in this productRead these instructions Safety instructions CE Declaration of Conformity About the Monitor One About the Monitor One chapter About near-field monitoring About the Monitor One chapter Avoid reflections Speaker placementReflection Listening triangle Symmetry Why not place tweeters to the outside? Use the correct polarity when wiring Connecting your speakers to an amplifierInstallation What size power amp should you use? Power and ProtectionShould I install a fuse?
Top Page Image Contents