Haier AB212BCBAA, 0010571570 manual Install wire controller

Installation procedure Install wire controller

1.Remove the upper cover of wire controller	Upper cover of
	wire controller

The PC board is installed on the back cover of wire controller. When remove the upper cover, pay attention not to damage PC board.

Back cover of wire controller

Switch

Screw hole

2.Install wire controller

**Drill 2 wall holes according to the position of the 2 screw holes on the back *cover of wire controller, then hit wood in the wall holes. Put the 2 screw holes *on the back cover of wire controller properly to its corresponding wood, then *use wood screws to fix the back cover on the wall.

Note:

Install the back cover of wire controller on the even wall as possible as can. When tightening the wood screw, do not use to tight force, otherwise the wire controller may be damaged.

Switch

Mark	ON	OFF	Note:
1	3 grades fan speed	2 grades fan speed	When connecting wire, please keep a
			certain distance between signal wire and
2	Have rise and drop	No rise and drop
			electric wire. (over 10mm)
3	Swing	Not Swing
4	The collection	The collection
	temperature of	temperature of		Dimension of signal wire:
	main panel	panel
				Type of wire	Shield wire (4 cords)
Under this series, the switch is set as:
				Dimension	0.33mm2
1.ON 2. OFF 3. OFF 4.OFF

3.Indoor unit wire connection			The connection between indoor unit
Connect the terminals (A, B, C, D,) on the wire
controller to the terminals on the indoor PC			and wire controller and indoor unit
			and outdoor unit should use shield
panel (A, B, C, D,) respectively.
			wire. And the two ends of the shield
Arrange wire from this part			wire	should	be	grounded,
AB	CD		otherwise, the disturbance will
	Back cover		cause unit abnormal operation.
	wire controller	Upper cover		Shield wire
		of wire
		controller		Grounded		Grounded

Note:

Confirm the connection part of terminals is firm and will not touch shield wire.

4.Cover the wire controller upper cover

Pay attention not to press the connection wire.

Note: Do not touch PC board by hand.

30