PHL Audio X30 specifications Typical Characteristics, THIELE-SMALL Parameters Typical QC Limits

4070

12” Coaxial Bass Midrange Driver

		4070
TYPICAL CHARACTERISTICS
Rated impedance	Z	8	Ω
Reference efficiency (1 W@1 m)	-	97	dB SPL
Usable frequency range 1	-	50–2500	Hz
Power handling capacity 2 (AES)	-	400	W
Max Sound Pressure Level 3	SPLmax	119	dB SPL
Min. impedance modulus	Zmin	6.5 @ 270Hz	Ω
Voice-coil inductance 4 @ 1 kHz	Le1k	1.07	mH
@ 10 kHz	Le10k	0.51	mH
Bl product	Bl	20.6	N/A
Moving mass	Mms	0.057	Kg
THIELE-SMALL PARAMETERS : TYPICAL (QC LIMITS)
Resonance frequency 5	Fs	47 (±6)	Hz
DC resistance 6	Re	5.5 (±0.6)	Ω
Mechanical quality factor	Qms	3.5	1
Electrical quality factor	Qes	0.22	1
Total quality factor	Qts	0.21	1
Mechanical suspension compliance	Cms	205	10-6m/N
Effective piston area	Sd	0.049	m2
Equivalent Cas air load	Vas	0.068	m3
Max. linear excursion	Xmax	± 5.5	mm
Linear displacement volume	Vd	0.270	10-3 m3
Half-space efficiency		3.1	%
Unity load volume	Vas Qts2	2.9	10-3 m3
ABSOLUTE MAXIMUM RATINGS
Short term max. input voltage 7	Vmax	115	V
Max. excursion before damage	Xdam	12	mm
Ambient operating temperature		–10 to +50	°C
Storage temperature 8		–20 to +70	°C
Environmental conditions 9		Outdoor
APPLICATION INFORMATION
Air volume occupied by the driver 10		2.6	10-3 m3
Speaker net mass		8.7	Kg
Recommended reflex box	Vb/Fb	50 / 53	L / Hz
Electrical polarity	A positive voltage applied on the red
	terminal produces forward cone motion.

PHYSICAL CHARACTERISTICS

max326.5	angles)(on	8 x Ø 6.5 Holes eq. spaced
		on Ø 300 and on Ø 308
Ø

		170
	dot	Ø 25.4
	Red
+
2 x screw button		76.2
	terminals
13		Ø 307 max.

128.5 max.

Ø204 max.

Ø281.5 max.

SPECIFICATION NOTES

Note 1 : Allowing for energy response, excursion capability, Power spectrum, and -3dB low freq. roll-off for standard reflex tuning.

Note 2 : Established at 20°C ambient temp, according to AES2-1984 standard using IEC268-1 simulated programme signal and a 50 liter Bass-Reflex test enclosure tuned at 53Hz.

Note 3 : Established at 1m on axis of the loudspeaker mounted

in test enclosure, when driven at full AES Power Handling Capacity, including 4dB of thermal compression loss.

Note 4 : Measured at 20 mA in free air.

Note 5 : Measured at 20 mA and 20°C ambient temp. in free air conditions, after full run and rest.

Note 6 : Measured at 20°C ambient temp.

QC limits are ±10%

Note 7 : Stated in RMS voltage according to IEC 268-5.

Note 8 : Includes shipping conditions. The lower limit prevents from demagnetization.

Note 9: Our products are classified in three categories : Indoor, Outdoor, and Outdoor✚ for permanent outdoor use or severe conditions.

Note 10 : Calculated for front mounting on to a 18 mm thick board.

461, rue des chênes ■ Z.A 77590 CHARTRETTES FRANCE

Tél : 33 01 64 81 29 80

Fax : 33 01 60 69 10 28

e-mail : phlaudio@phlaudio.com

http: //www.phlaudio.com

PHL Audio S.A. provides these specifications as representative of current production after conditioning. Because of our continuous research, they are subject to change without notice.