In-Wall Installation

PIEGA AP 3, AS 3

Positioning and mounting instructions...

The AP 3, AS 3 loudspeakers can be flush mounted in a wall using a special mounting bracket so that only the loudspeaker front and bracket frame are visible after mounting. This space saving mounting method allows you to enjoy the benefits of both quality sound and a discrete design (refer to the alignment instructions on page 16).

Mounting the flush-mounting frame:

>With concrete walls, the flush-mounting bracket must be mounted in the recess at the required position without the loudspeaker (!) before the wall is completed, i.e. when the wall is being built

>Bear in mind that empty conduits for the loudspeaker cables and power supply cables (only for the active versions) must also be provided in the recess - The holes required for this must be provided by the customer...!

>The loudspeakers and the flush-mounting frame have an asymmetric design, and so left/right alignment must be ensured

(Alignment instructions see page 16)

Fitting the loudspeakers in the flush-mounting frames:

>The loudspeaker should only be mounted and connected once the building work is fully completed

>First of all, connect the loudspeaker cables to the terminals provided (see the next page) and then mount the loudspeakers using the two screws (see drawing)

>Do not mount the front panel until the end when the loudspeakers are completely installed and connected

Note:

Consult a specialist, i.e. the person responsible

from the building company with regard to the mounting without fail...!